Beta 599DGT-AN/10 Manual De Uso E Instrucciones página 15

ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS
TORQUE WRENCH OPERATION
Powering on/off and resetting torque wrench
– Press to power on the digital torque wrench.
– In the "torque" mode, the screen will display a preset value.
– In the "angle" mode, the wrench allows torque + angle tightening, directly switching from the first to the second size.
The wrench will take a few seconds to be set; then the set degree and torque values will alternate on the screen.
– Always press to reset the digital torque wrench before using it.
– The wrench will auto sleep after about 2 minutes idle for power saving. Press to wake up the wrench during the sleep
mode.
– If the wrench does not function normally, press together to reset the wrench.
– Keep pressed, to power the digital torque wrench off.
If an external force is applied to the torque wrench during the power-on/reset or wake up period, an initial torque offset
will be found in the memory. Applying an external force while resetting may result in an error.
If the message is shown on the screen, the wrench will have to be reset.
When the wrench is used in the "angle" mode, it should be placed horizontally on a plane before any values are
changed. If this instruction is not followed, a set of angle indicators will start blinking on the dial:
To start the wrench, press
If the battery voltage is under 2.3 V, the wrench will display a battery symbol and then turn off after a while.
EN I
15