Power Supply; General Operation - Nevir NVR-470 Manual De Instrucciones

POWER SUPPLY

If you would like, the electrical power supply can be used to save the batteries. Make sure that the unit is
unplugged from the wall outlet before inserting the batteries.
USING THE DC POWER SUPPLY
Batteries (not included)
Open the battery compartment and insert 6 R14 batteries with respect to the "+" and "-" polarity indications
in the compartment.
Warnings relating to the use of batteries
Batteries must be inserted taking care to match the polarities shown. Make sure that the (+) and (-)
terminals are placed in the right direction.
Never use batteries that show signs of electrolyte leaks or cracking.
Never dispose of used batteries in an open fire.
Keep batteries out of reach of children.
Never recharge disposable batteries.
Never short circuit battery terminals.
Always remove used batteries from the appliance case.
Do not try to open the batteries.
Do not mix up different kind of batteries or new and already used batteries together.
Only use batteries of the recommended or equivalent type.
Remove batteries from the appliance before disposing of it at the end of its service life.
Important:
When replacing the batteries, make sure you dispose of the old batteries in accordance with applicable
regulations. They should be disposed of in a location specifically designated for that purpose so they can
be recycled safely and without posing any risk for the environment. Do not burn or bury them.
Warnings: excessive sound pressure from earphones and headphones can caused hearing loss.
USING THE AC POWER SUPPLY
1. Make sure that the voltage indicated on the manufacturer's nameplate in the battery compartment
corresponds to the voltage supplied by your electrical installation. If this is not the case, consult your
dealer or service center.
2. Connect the electrical power cable the unit then plug it into the wall outlet. The wall outlet must be
located near the product and be easily accessible.
3. To turn power to the apparatus off, unplug the power supply cable from the wall outlet.
4. To protect the unit during violent thunderstorms, unplug the power supply cable from the wall outlet.
ENG-6

GENERAL OPERATION

GENERAL OPERATION
1. Select the source by setting the FUNCTION SELECTOR to AM, FM ST., OFF or CD/MP3.
2. Set the desired volume level using the VOLUME CONTROL.
3. To turn off the unit, set the FUNCTION SELECTOR to OFF.
RADIO RECEPTION
1. Adjust FUNCTION SELECTOR to AM or FM ST..
2. Turn the TUNING KNOB to search for the desired station.
NOTE: The FM stereo indicator comes on if the BAND SELECTOR is set on FM stereo and you have tuned
the radio to an FM stereo station.
4. Adjust VOLUME CONTROL for the desired volume level.
5. When you have finished listening to the radio, position the FUNCTION SELECTOR to OFF to turn the
unit off.
Helpful hints:
To improve radio reception
To listen to the FM radio, extend the telescopic antenna and orient it for optimum reception. Reduce
the length of the antenna if the signal is too strong (if you are very near the transmitter, for example).
As the unit is equipped with a built-in antenna, the telescopic antenna does not have to be used to
listen to AM stations. Move the entire unit to orient the built-in antenna.
STEREO HEADPHONE JACK
Plug stereo headphones (not included), equipped with a 3.5mm mini-plug, into the PHONES jack for private
listening, without disturbing those around you.
Reduce the VOLUME to a low level before putting on the headphones. You can then adjust the VOLUME
progressively to a comfortable level.
Noted: The speakers will be muted when headphones are connected to the set.
ENG-7