SAFETY PRECAUTIONS
IMPORTANT INFORMATION
This product is designed for use in moderate climate. Do not use or install this unit where it would be
exposed to direct sunlight or in extremely hot temperatures, or near a radiator, stove or appliance that
produces heat.
Do not take this unit into the bathroom, or near a swimming pool. Do not use it where it would be exposed to
water, moisture, dripping or splashing.
No objects filled with liquids, such as vases, placed on the product.
No naked flame sources, such as lighted candies on the product.
If water gets inside the unit, Unplug the power cord from the supply socket and consult your dealer.
Do not handle the power cord with wet hands. To avoid electric shock, NEVER touch any internal parts.
Repairs/servicing should be left to qualified service personnel.
When connecting or disconnecting from the mains supply, hold the plug but not the cord. Pulling the cord
may damage it and is dangerous.
Do not drop the unit, spill liquid into it or allow objects to fall in it.
When plugged in, a very small current will flow. To save electricity and for safe, it is recommended that the
product is completely disconnected with the AC mains socket after the unit not used for a long time.
Consult your nearest dealer when damage, disconnection or contact failure is found with the cord.
Do not bend the cord sharply, pull or twist it.
Do not modify the power cord in any manner.
Do not insert any metallic object in the unit.
Unplug the power cord when there is the possibility of lighting.
Mains plug is used as the disconnecting device. It shall remain readily operable and should not be
obstructed during intended used.
To be completely disconnected the apparatus from supply mains, the mains plug of the apparatus
shall be disconnected from the mains socket outlet completely.
In case of malfunction due to electrostatic discharge, just reset the product reconnect of power source
may be required to resume normal operation.
POSITIONING THE UNIT
A minimum distance of 6 INCHES must be kept to provide sufficient ventilation.
Do not place the product in closed bookcases or racks without proper ventilation.
Allow adequate ventilation for the unit ventilation. It should not be impeded by covering the ventilation
openings with items such as newspapers, table cloths, curtains etc .
Do not stand it on a thick pile carpet, install it in a thick pile carpet, or install it in a place with inadequate air
flow. Place the unit on a flat even surface.
Do not use the unit in excessively hot, cold, dusty, damp or humid place.
Condensation may form inside the CD player if the unit is left anywhere warm and damp, or if you move the
unit from somewhere cold to a warm room. In this case, let the unit stand for 1-2 hours or gradually increase
the room temperature that the unit will be dry before use.
ENG-2
SAFETY PRECAUTIONS
Do not place it where it could be subject to vibration.
Do not place it where it could be magnetised by a magnet or speaker. Since there are magnets, do not place
tapes as recorded data could be erased.
When this unit is used near a TV, the TV picture could be distorted. If this happens, move the unit away form
the TV. If the situation could not be solved, avoid using the unit when the TV is turned on.
Keep the CD door closed so the lens is not contaminated by dust. Do not touch the lens.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Warning: excessive sound pressure from earphones and headphones can cause hearing loss.
Attention should be drawn to the environmental aspects of battery disposal.
SAFETY MECHANISM
This unit incorporates a safety interlock mechanism that switches the laser beam on and off, when the disc
holder is open, the laser baser beam stops automatically.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
ENG-3