Tempo MM200 Manual De Instrucciones página 11

Operation (cont'd)
Settings Table (cont'd)
To measure this
characteristic ...
All Models (cont'd)
Frequency—Line Level
Voltage or Current
Frequency—Logic Level***
EF
single probe†
EF
non-contact†
DM-210A and DM-510A Only
* Tone indicates continuity. The threshold is between 10 Ω and 80 Ω.
** Press SELECT for AC or DC, as required.
Capacitance††
*** Logic level frequency has a fixed sensitivity and is for digital signals. Refer to "Accuracy".
† Refer to the "Using the Features" section for an explanation of EF (electric field detection).
†† Discharge capacitor before measurement. Discharge a large capacitor through an
Temperature
appropriate resistive load.
DM-510A Only
Auto select AC volts, DC volts,
resistance, and continuity (low
impedance measurement)
* Tone indicates continuity. The threshold is between 10 Ω and 80 Ω.
** Press SELECT for AC or DC, as required.
*** Logic level frequency has a fixed sensitivity and is for digital signals. Refer to "Accuracy".
† Refer to the "Using the Features" section for an explanation of EF (electric field detection).
†† Discharge capacitor before measurement. Discharge a large capacitor through an appropriate
resistive load.
Set the These icons will
selector to this appear on the
symbol ...
, A, mA, or µA
and press Hz
mV and press Hz
Any voltage or
current function
and press EF for
at least 1 second
Ω
and press
SELECT
Temp (press SELECT to
change scale)
AutoCheck
11
DM-200A • DM-210A • DM-510A
Connect
the red
display ... lead to ...
Hz ΩV
Hz ΩV
ΩV
E.F.
—
Temp
ΩV
nF
C or F
Temp
ΩV
Temp
ΩV
and LoZ
MM200A
Connect
the black
lead to ...
COM
COM
—
—
COM
COM
COM
13