Installation; Placement And Mounting; Fixing And Hanging The System - Ecler EPC200 Manual De Instrucciones

EPC215B
Equipped with two 15" loudspeakers with a potent ceramic magnet and 100mm coils,
able to support up to 7.5mm displacements. A 2" high efficiency compression engine coupled to a
constant directivity diffuser made of non-resonant plastic is used for the treble band. Dimensions:
high x wide x depth, 1140x500x420mm. Have transport handles and fixing parts.
EPC218
Bass reinforcement. Equipped with two 18" loudspeakers with a potent ceramic magnet
and 100mm coils, able to support up to 7mm displacements. Efficiency: 102dB 1W/1m.
Dimensions: high x wide x depth, 1140x500x710. Have transport handles.

3. INSTALLATION

3.1. Placement and mounting

The acoustic characteristics of the room, hall... and the number of assistants must be
taken into account. General rules valid for any case: place the acoustic cabinets on solid and firm
surfaces. The bass reinforcement cabinets are more efficient when are placed directly on the floor
in an oblong position rather than vertical or elevated or hanged. We recommend to place the bass
cabinets vertical for a better sound quality.
Be sure that there is not any obstacle between the mid-treble cabinets and the audience;
the high frequencies are extremely directive and any obstacle represents an attenuation. For a big
audience, the higher you place the mid-treble cabinets, the better sound propagation you will get.
Although all the EPC cabinets protect the loudspeakers with a grille and a foam do not expose the
system to the sun for long periods and avoid the rain.
The EPC200 operates (depending on country) under 110, 120, 220, 230 or 240V AC
50/60Hz. See characteristics in the back of the unit. You should avoid mixing the mains wire
with and in between shielded signal cables, because this could generate noise and hum.
In order to protect the mixer from eventual mains overloads or occasional excesses in
the consumption of the internal circuits, it has a 250mA (20) mains protection fuse. Should this
fuse ever blow off, disconnect the unit from mains and replace it for an identical one. If the
new fuse also blows ask our Authorised Technical Service. NEVER REPLACE THE FUSE WITH
ANOTHER ONE WITH A HIGHER VALUE.

3.2. Fixing and hanging the system

The EPC215B acoustic cabinet have three fixing holes, two
on the sides and one on the back, specially designed to hang the
box. Use the FL 200 ECLER KIT, composed by 3 T-shaped metallic
pieces and safety rings, to hang the cabinets. Because of the weight
of the acoustic cabinet we recommend to use chain or steel wire and
metallic wallplugs.
Fig.1
5