Before the appliance is used, it must be properly positioned and installed as
described in this manual, so read the manual carefully. To reduce the risk of fire,
electrical shock or injury when using the appliance, follow basic precaution,
including the following:
It is recommended that a separate circuit, serving only your appliance be provided. Use
receptacles that cannot be turned off by a switch or pull chain.
Never clean appliance parts with flammable fluids. These fumes can create a fire hazard or
explosion. Do not store or use gasoline or other flammable vapors and liquids near this or any
other appliance. The fumes can create a fire hazard or explosion.
Before proceeding with cleaning and maintenance operations, make sure the power line of the
unit is disconnected.
Unplug the appliance or disconnect power before cleaning or servicing. Failure to do so can result
in electrical shock or death.
Do not attempt to repair or replace any part of your appliance unless it is specifically
recommended in this manual. All other servicing should be referred to a qualified technician.
This appliance shall not be used for space heating. The surface unit should not be operated
without cookware. This information is based on safety considerations.
All openings in the wall behind the appliance and in the floor under the appliance shall be sealed.
Keep appliance area clear and free from combustible materials, gasoline, and other flammable
vapors.
Do not obstruct the flow of ventilation air.
Disconnect the electrical supply to the appliance before servicing.
When removing appliance for cleaning and/or service:
Disconnect AC power supply.
Carefully remove the range by pulling outward.
CAUTION: Range is heavy. Use care in handling.
The misuse of oven door (e.g. stepping, sitting, or leaning on them) can result in potential hazards
and /or injuries.
When installing or removing the range for service, a rolling life jack should be used. Do not push
against any of the edges of the range to slide it into or out of the installation. Pushing or pulling a
range (rather than using a lift jack) also increases the possibility of bending the leg spindles or the
internal coupling connectors.
It is important for the appliance to be leveled to work properly. You may need to make several
adjustments to level it.
Never allow children to operate, play with or crawl inside the appliance.
Electrical Grounding Instructions - The appliance must be installed and grounded by a qualified
technician in accordance with the National Electrical Code ANSI/NFPA No. 70 (Latest Edition)
and local electrical code requirements.
Replacement Parts – Only authorized replacement parts may be used in performing service on
the range. Replacement parts are available from factory authorized parts distributors. Contact the
nearest service center in your area.
IMPORTANT SAFEGUARDS
3