Electrical Connection - Premium PRE2015GW Manual De Instrucciones

 ELECTRICAL CONNECTION

The appliance must be properly installed and grounded by a qualified technician in accordance
with the National Electrical Code ANSI/NFPA No. 70 (Latest Edition) and local electrical code
Improper grounding can result in the risk of electrical shock. If the power cord is damaged, have it
requirements. Installation should be made by a licensed electrician.
replaced by an authorized service center.

The range may be connected by means of permanent "Hard Wiring" or "Power Supply Cord Kit".
Power supply cord is not supplied but is available through your local electric supply house.

Use only 3-conductor or 4-conductor UL listed range cord rated at 40 amps with 125/250V
minimum voltage range. These cords may be provided with strain relief or conduit connector.

The range must be connected to the proper electrical voltage and frequency as specified on the
rating label.

The range can be connected directly to the fused disconnect (or circuit breaker box) through
flexible, armored or non-metallic sheathed, copper cable (with grounding wire). Allow two to three
feet of slack in the line so that it can be moved if servicing is ever necessary.

For personal safety, the range must be properly grounded.

Remove house fuse or open circuit breaker before beginning installation.

Do not attempt to repair or replace any part of the appliance unless it is specifically recommended
in this manual. All other servicing should be referred to a qualified technician.

To minimize the possibility of electric shock, disconnect this appliance from the A/C power supply
before attempting any maintenance.
NOTE: Turning the appliance off does not disconnect the appliance from the power supply. We
recommend having a qualified technician service your appliance.
WARNING
12