Troubleshooting Guide - HAEGER GH-42B.002A Instrucciones De Uso

English
• Following the steps described under "Assembling the heater and
connecting the gas cylinder" for connecting a new cylinder.
Cleaning
• Maintenance and cleaning must be carried out with the gas supply turned
off and the heater must be cold. Do not attempt to clean the heater while
it is in use.
• Your heater should be checked annually by a qualified person for safe
operation and to detect any faults.
• Stop using the heater and contact your dealer for advice if any faults are
detected in use.
• Periodically clean the exterior and rear cylinder, storage area of your
heater to remove dust, which may affect the operation of the heater.
• Light vacuuming with a soft brush will remove any dust build-up on the
surfaces of the ceramic elements. Do not scrape these elements as they
may become very fragile with use.
• Do not use abrasive products to clean the heater.
• Watch the pilot flame while it is in operation. It should burn steadily, if it
flickers or is yellow tipped, the heater should be checked for correct
operation.
• If any parts need replacement, they must be replaced only with genuine
original parts supplied by the manufacturer. The use of incorrect or
substitute the parts may be dangerous and will void any warranty.
When the heater is not in use for a period of time, for instance, over the
summer, we recommend that it be kept covered or replaced in its
carton to minimize the accumulation of dust and dirt that may occur.

Troubleshooting guide

The heater doesn't light:
• Check the gas cylinder if it is full
• Check the regulator if it is properly attached and the cylinder valve is
turned on.
• Check if the instructions have been followed correctly.
The heat doesn't light after the cylinder has been changed it could be
due to:
8 Instructions for use