GE GXMH31H Manual Del Propietario E Instrucciones De Instalación página 21

Programming the Water Softener
FEATURE: OTHER DATA DISPLAY
These models have an option to have the run
display indicate different information. The information
displayed on the top half of the display can be
changed to one of the following by pressing UP
or DOWN buttons:
• CAPACITY REMAINING
– This is the percentage
of water softening capacity
remaining. Immediately after a
regeneration, 100% shows. As
water is used, the percentage
will decrease until the next regeneration. During
regenerations, the percentage increments upward.
When present time is displayed, press the DOWN
button; % Remaining will appear in the display.
The value shown is between 0 and 100 percent.
This value is based on current operating capacity.
Pressing the UP
the previous display.
• AVERAGE DAILY
GALLONS – The figure
displayed is the average
gallons of water used by the
household each day over the
past seven-day period.
Press the DOWN
Average Daily Gallons. Average Daily Gallons will
appear in the display. This value is updated every
night at midnight. Pressing the UP
return the screen to the previous display.
• FLOW RATE, GPM
– When using soft water, this
display shows the flow rate
passing through the softener
(in gallons per minute). Zero
shows if water is not passing
through the softener.
Press the DOWN
flow rate. Gallons/Min will appear in the display.
This value is updated every
UP button will return the screen to the previous
display. Pressing the DOWN
the screen to the present time display.
Days to Empty
Recharge
Tonight
button will return the screen to
Days to Empty
Recharge
Tonight
button again to display the
button will
Gallons/Min
Days to Empty
button again to display the
1 2 second. Pressing the
button will return
RESETTING TO FACTORY DEFAULT
To reset the electronic controller to its factory
default for all settings (time, hardness, etc.):
1. Press the MODE/SET button and hold
until the display changes twice to show the
flashing mode code.
2. Press the UP
"SoS".
% Remaining
3. Press the MODE/SET button and the
electronic controller will restart.
4. Set the present time, hardness, etc, as
described in the Programming the Water
Softener section
Average Daily
Gallons
21
button to display a flashing