Problems, Causes & Solutions - Mr Coffee BVMC-ECMP60 Manual Del Usuario

PROBLEMS, CAUSES & SOLUTIONS
PROBLEMS POSSIBLE CAUSES
Coffee does • No water in reservoir.
not come out. • Coffee grind is too fine.
• Too much coffee in the
filter.
• Appliance was not turned
on or plugged in.
• Filter is clogged and needs
to be cleaned.
No steam is • Water reservoir is empty.
generated.
• Appliance is not turned on.
• Frothing wand is blocked.
Milk is not • Milk is not cold enough.
foamy after
frothing. • Frothing wand too deep in
milk.
Coffee comes • Ground coffee is too
out too quickly. coarse.
• Not enough coffee in filter
basket.
14
SOLUTIONS
• Add water.
• Grind coffee to espresso
ground.
• Fill filter with less coffee.
• Plug unit into electrical
outlet.
• Clean filter.
• Fill reservoir with correct
amount of water.
• Turn on unit and follow the
operating instructions.
• Following frothing stage,
operate frothing function
for 1-2 seconds to extract
excess milk. Remove the
frothing wand cover and
clean with a needle or
toothpick.
• Chill milk and frothing
pitcher prior to frothing.
• Submerge wand ½ - 1" in
milk when frothing.
• Use a finer grind.
• Use more coffee.
PROBLEMS POSSIBLE CAUSES
• Too much water is used.
Coffee is
• Ground coffee is too
too weak.
coarse.
Brew Button and • Knob turned to Brew or
Steam when unit is plugged
Steam Button
Lights flashing in or before ready light
alternately. is on.
• Reached maximum brew
Both Brew Button
time of 1.5 minutes.
and Steam Button
• Frothing while on Brew
Lights are flashing
mode and Brewing while on
at the same time.
Steam mode.
Brew Button • The internal heater is
Light flashing. too hot.
Brew Button • The unit is not plugged in.
indicator light • The On/Off (I/0) switch is
is not on. not turned on.
• The unit is in sleep mode.
The Steam • The Steam button was not
Button indicator pressed.
light is not on.
Coffee spill out • Espresso cup is not
of glass espresso positioned properly.
cup provided
(certain models).
SOLUTIONS
• Manually stop the brew
earlier by turning the
control knob to Stop.
• Use a finer grind.
• Turn Knob to Stop,
make sure ready light
is on before turning to
Brew or Steam.
• Turn Knob to Stop.
• Unplug the unit for 10
minutes.
• Run water through the unit.
Hold a cup under the frothing
wand, press the Brew button
and turn the control knob to
Steam. The unit will start to
pump water for 10 seconds,
then stop automatically. Then
turn the control knob back to
stop and discard the water.
• Plug in unit.
• Press the I/0 switch on (I)
on one side of the unit.
• Press the Brew Button.
• Make sure to press the
Steam Button.
• Make sure you place
espresso cup in the center
of the tray underneath the
two portafilter streaming
spouts.
15