Problems And Causes - Mr Coffee BVMC-ECMP55 Manual De Instrucciones

PROBLEMS AND CAUSES

PROBLEM CAUSES
Coffee • No water in
does not reservoir.
come out • Coffee grind is too
fine.
• Too much coffee in
the filter.
• Appliance was
not turned on or
plugged in.
• Coffee has
been tamped/
compressed too
much.
Coffee • Filter holder not
comes out rotated to full lock
around the position.
edge of • Coffee grounds
the filter
around the filter
holder basket rim.
• Too much coffee in
the filter basket.
Milk is not • Ran out of steam.
foamy after
frothing
• Milk is not cold
enough.
BVMC-ECMP55_13ESM1.indd 21-22
SOLUTIONS
• Add water.
• Grind coffee
medium ground.
• Fill filter with less
coffee.
• Plug unit into
electrical outlet.
Turn it on.
• Refill filter basket
with coffee DO NOT
TAMP.
• Rotate filter holder
to full lock position.
• Wipe off rim.
• Fill with less coffee.
• Ensure there is
enough water in
the reservoir.
• Chill milk and
frothing pitcher
prior to making
cappuccino.
E19
PROBLEMS AND CAUSES
PROBLEM CAUSES
No • Water reservoir is
steam is empty.
generated
• Appliance is not
turned on.
• Frothing tube is
blocked.
Coffee • Ground coffee is
comes out too coarse.
too quickly • Not enough coffee
in filter basket.
Coffee is • Using small filter for
two demitasses.
too weak
• Too much water is
used.
• Ground coffee is
too coarse.
E20
SOLUTIONS
• Fill reservoir with
correct amount of
water. See Page
E10 and E11.
• Turn on unit
and follow
the operating
instructions.
• Following frothing
stage, operate
frothing function for
1 – 2 seconds to
extract excess milk.
Or, turn off unit,
allow unit to cool,
unplug unit and
clean out frothing
tube with a needle
or toothpick.
• Use a finer grind.
• Use more coffee.
• Use large filter for
two demitasses.
• Manually stop the
brew earlier by
turning the side
knob clockwise to
the off " "position.
• Use a finer grind.
2/22/13 2:26 PM