Disposal Instructions - Respireo Primo F Manual De Uso

12 - DISPOSAL INSTRUCTIONS

The components of the mask are made of the following materials and must be disposed of in accordance
with the applicable laws.
COMPONENT
Main body
Forehead support
Adjusting knob
Adjusting screw
Anti-suffocation fitting
Anti-suffocation valve
Swivel fitting
Forehead rest
Cushion
Cap
Headgear
Clip
13 - TECHNICAL DATA
MINIMUM CONTINUOUS FLOW
N.B. Due to manufacturing differences, the exhalation flow rate may differ from the values shown in
the table.
Normative references
Resistance
Operating pressure
Temperature range
Dead space volume inside the mask 215 ml (Large)
WARRANTY
Refer to the general warranty conditions. The Manufacturer is liable for the safety, reliability and performance of the apparatus,
provided that it is used in accordance with the instructions and for the intended purpose only, and that any repairs are made
by the Manufacturer or an approved service centre.
The Manufacturer declines all liability and the warranty will be invalidated if the user fails to follow the instructions and the
important notes contained herein.
COPYRIGHT
The information contained in this booklet may not be used for anything other than the intended purpose. This booklet is
the property of Air Liquide Medical Systems S.p.A and no part of it may be reproduced without the manufacturer's written
permission. All rights reserved.
TECHNICAL UPDATES
Air Liquide Medical Systems periodically reviews and modifies all its medical devices in order to improve their performance,
safety and reliability. The instruction booklets are updated to ensure that they continue to be consistent with the characteristics
of the devices marketed.
If the booklet accompanying the apparatus is mislaid, a replacement copy can be obtained from the Manufacturer by
quoting the data shown on the label.
ENGLISH • ENGLISH • ENGLISH • ENGLISH • ENGLISH • ENGLISH
RESPIREOPRIMOF822.108.indd 10
MATERIAL
Polycarbonate
Polycarbonate
Polypropylene
Nylon
Polycarbonate
Silicone
Polycarbonate
Silicone
Silicone
Silicone
Nylon/polyurethane
Nylon
CE marking in accordance with European Directive 93/42/EEC,
class IIa
EN ISO 14971, ISO 5356-1, ISO 10993-1, EN ISO 17510-2
at 50 lpm: 0,3 cmH
4 - 24 cm H
2
5°- 40°C
Mask Pressure (cmH2O)
Flow Rate (lpm) (± 6 lpm)
O - at 100 lpm: 0,6 cmH
2
O
4 8 12 16 20
21 32 42 49 55
O
2
02/03/11 10:34