Warranty Conditions - SOLAC CVG 96 Serie Instrucciones De Uso

• U nplug the CVG and fill the tank with the beaker that is supplied Fig 1 (12), in the vertical position as
shown in figure Fig 3.
• I f the appliance were to run out of water completely, you would hear a strange noise from the
micro-pump. In this case, unplug the appliance and fill the tank with water. When you switch it on
again, this noise will disappear.
ANTICALC - SYSTEM
If you do not change the resin of your CIS it will be affected by scale just like other ironing systems.
• T he Compact Vapor Generator is fitted with a replaceable anticalc - system consisting of a resin filter,
which retains the limy substances in the water, preventing these from reaching the steam chamber in
the sole-plate and thereby extending the life of your CVG. If you so wish, on this model you may replace
the resin so that the CVG is kept in optimum condition. If you want to replace the resin, we recommend
you to do it every 6 months. Changing the resin does not mean that you may overlook the advice about
water hardness given in the section "BEFORE STARTING TO IRON" .
• I n the event of not changing the resin of this CVG, it will be subject to the effects of scale just like
other irons.
• F or replacement and before removing it, make sure there is no water in the tank.
• T urn the part, situated in the heel of the appliance, in an anticlockwise direction as far as it will go, and the
arrow lines up with the open padlock (approx. 180º) and pull it back.
• T o replace it, line up the arrow with the open padlock and turn it in a clockwise direction, fol-
lowing the directions in the drawing, pressing the part inwards at the same time, until reaching
the padlock closed position Fig 3.
• W hen the filter is in place, make sure that it DOES NOT STAND OUT of the back of the iron, otherwise
you will not have fitted it properly and water will leak from the tank.
CLEANING
A) Sole-plate
• U nplug the iron and let it cool down.
• U se environment-friendly clay-based products to clean the sole-plate.
B) Outside
• T o clean the outside of your CVG, use a cloth moistened in soapy water.
• D o not clean with abrasive chemical products or solvents as it may attack certain plastic parts and
/ or remove some of the marks and / or indications.
• S tore your CVG in the vertical position, wind the cord round the heel and secure it with the clip.
• Although the power cord is fitted with a 360º rotational elbow, NEVER FORCE this cord when
winding it around the appliance on the first turn.
TIPS FOR DISPOSING OF
THE USED APPLIANCE
• B efore disposing of your used appliance, you should make it visibly unserviceable and have it disposed of
according to current national legislation.
• A sk your Distributor, Town Council or Local Authority for detailed information.

WARRANTY CONDITIONS

• S olac accepts no liability for faults in your appliance in the event of noncompliance with the specifications
of the warranty conditions or failure to follow the operating or maintenance directions included in the
instruction brochure for every appliance.
• T he warranty conditions may be found in the accompanying "Word-Wide Guarantee" booklet.
• W e remind you that the damage caused by the effects of scale is not covered by the guarantee.
12
CVG9601.indd 12 28/10/09 17:40:04