About The Erp - Teac NP-H750 Manual Del Usuario

About the ErP

This product is compliant with the European ErP Standby
Power Regulation. In order to comply with this regulation, the
automatic power saving function of this unit is set to 30 min-
utes when shipped new, so the unit will automatically enter
standby if 30 minutes pass under the conditions shown in the
following table.
However, when "On" is selected for the network standby set-
ting (page 37), this function is not active. ( The default
network standby setting is "Off".)
p When you turn on the unit, the selected source is the
one selected before the unit was put into standby.
p During playback in iPod mode, if you put the unit into
standby by pressing the STANDBY/ON button, the next
time the power is turned on again, the unit will be in
iPod mode and playback will start automatically when
an iPod/iPhone/iPad is connected. Playback will not
start automatically in other modes.
Status AirPlay, USB flash
iPod/ drive
iPhone/
iPad
No

connection
Stopped/
*
paused
No input -
signal
External input: USB Audio In, COAXIAL, OPTICAL, PHONO,
AUX 1/2
 Automatic power saving function active
- Automatic power saving function not active
* Compatible only with AirPlay
/ Not applicable
Media External
player input
Internet
  
 
- -

Listening files on a USB flash drive (1)
You can play audio files stored on a USB flash drive by con-
necting it to this unit.
For details on playable files, see page 8.
1
Press the SOURCE button repeatedly to
select "USB/iPod".
p You can also use the USB/iPod button to select this
directly.
p "Not Connected" will be displayed if no USB flash
drive is connected.
2
Connect a USB flash drive to the unit.
3
Select the file you want to play.
For details, see page 29.
4
Press the play/pause button (y /9 ) or
ENTER button to start playback.
p If you press the / button when a file is
displayed, playback will also start.
27 27