Listening To An Ipod/Iphone/Ipad - Teac NP-H750 Manual Del Usuario

Listening to an iPod/iPhone/iPad (1)

For detailed information about compatibility, see page 10.
p The following explanations refer to an iPod, but they
also apply to use with an iPhone or iPad.
1
Press the SOURCE button repeatedly to
select "USB/iPod".
p The remote control's USB/iPod button can also be
used.
p "Not Connected" will appear when no iPod is
connected.
2
Connect an iPod to this unit using the USB
cable supplied with the iPod.
The iPod automatically turns on and starts playback
from the iPod music list.
32 32
p When the iPod is connected while a mode other
than iPod/USB mode is selected in the NP-H750, the
iPod will turn on and enter pause mode.
p If an iPod is connected to this unit, it will only be
recharged when this unit is ON.
p Recharging will stop when the iPod is fully recharged.
p Recharging is not possible when this unit is in standby.
Pausing playback
Press the play/pause button (G/J) to pause playback.
Playback stops at the current position.
To resume playback, press the play/pause button (G/J)
again.
Skipping to the next or previous file/
track
During playback or when paused, press the skip buttons
(.//) repeatedly until the desired file/track is found.
p When the . button is pressed during playback, the
file/track being played will be played from the begin-
ning. If you want to play the previous files/tracks, press
the . button twice or more.