Additional Safety Instructions; Specific Safety Rules - Workzone 50450 Manual Del Usuario

13Amp 7-1/4in. Circular Saw
may operate sluggishly due to damaged parts, gummy deposits, or a
build-up of debris.
c) Lower guard may be retracted manually only for special cuts such as "plunge
cuts" and "compound cuts." Raise lower guard by retracting handle and as
soon as blade enters the material, the lower guard must be released. For all
other sawing, the lower guard should operate automatically.
d) Always observe that the lower guard is covering the blade before placing
saw down on bench or oor. An unprotected, coasting blade will cause the
saw to walk backwards, cutting whatever is in its path. Be aware of the time
it takes for the blade to stop after switch is released.

Additional safety instructions

1) Do not use any abrasive wheels.
2) Wear a dust mask, if the work causes dust.
3) Use saw blades recommended by manufacture.
4) Wear ear protectors when using the tool for extended periods.
5) Be sure to inspect material. Avoid cutting other different material.
6) Be careful not to drop the tool.
7) Never swing the tool.
8) Never cover the ventilation slots, and keep them free from dust or other material.
9) Do not clamp the tool in a vise. Never cut with the tool held upside down in a
vise. This is extremely dangerous and can lead to serious accidents.
10) Never wear knitted gloves.
11) Be sure no one is below when using the tool in high locations.
12) Do not touch the blade immediately after operation. It may be hot and could
burn your skin.
13) Do not touch material after it has been cut. Cut material may be very hot.
14) Do not use cutting oil. This use of cutting oil may cause a re.
15) Do not cut workpieces covered or stained with gas, oil, solvents, thinners, etc.
Exposure to these materials may damage the transparent guard.
16) Do not remove the transparent and lower guards. If the transparent and
lower guards is damaged or missing, return tool to authorized service center
for replacement.
17) Do not start the blade when in contact with workpiece. Wait for blade to
reach full speed before beginning cut.

SPECIFIC SAFETY RULES

• Hold tool by insulated gripping surfaces when performing an operation
where the cutting tool may contact hidden wiring. Contact with a "live"
wire will also make exposed metal parts of the tool "live" and shock the
operator.
13
acs@americancustomerservice.com
Power Tool Use & Care
AFTER SALES SUPPORT
1800 505 8311
USA
USA