Using The Parallel Fence; Using The Laser Guide - Workzone 50450 Manual Del Usuario

USA
13Amp 7-1/4in. Circular Saw Operation& Electrical Safety

USING THE PARALLEL FENCE

The parallel fence (8) allows you to make parallel cuts in a sheet of wood, all
at the same width.
Loosen wing screw. Slide the parallel fence (8) through the slots in the base
plate (5). Adjust the parallel fence to the required width and secure it in
position with wing screw.
NOTE
Ensure that the parallel fence rests against the wood along its entire length
to give a consistent parallel cut.
Wing screw

USING THE LASER GUIDE

Press the laser on button according to your requirements,or you can switch
off the button when it is not neccessary.
Laser on/off button
Do not stare directly at the laser beam.
Never aim the beam at any person or an object other than the workpiece.
Do not deliberately aim the beam at personnel and ensure that it is not
directed towards the eye of a person for longer than 0.25s.
Always ensure the laser beam is aimed at a sturdy workpiece without
re ective surfaces. I.e. wood or rough coated surfaces ard acceptable.
Bright shiny re ective sheet steel or the like is not suitable for laser use as
the re ective surface could direct the beam back at the operator.
Only turn laser beam on when tool is on workpicec.
AFTER SALES SUPPORT
6
1800 505 8311 acs@americancustomerservice.com
USA