Adjusting The Bevel Angle - Workzone 50450 Manual Del Usuario

13Amp 7-1/4in. Circular Saw
Check carefully that there are no cracks or other damage to
the saw blade.
WARNING
Replace any cracked blades immediately.
CAUTION. Always ensure that the saw is switched off and unplugged
from the power supply before making any adjustments.
• Loosen lever
• Lift the body of the saw until the blade is at the right depth - as shown
on depth adjustment scale
• Tighten lever
NOTE
Always use the correct blade depth setting. The correct blade depth
setting for all cuts should not be more than 6.35mm (1/4") below the
material being cut. Allowing more depth will increase the chance
of kickback and result in a rough cut.

ADJUSTING THE BEVEL ANGLE

Loosen knob and tilt the body of the saw until the required angle is
reached using scale as a guide.
Tighten knob NOTE. Always make a trial cut in a scrap piece of material
along a guideline to check the position of the blade relative to the guide-
line and the angle of cut.
5
acs@americancustomerservice.com
Depth adjust
Angle lock knob
Operation& Electrical Safety
AFTER SALES SUPPORT
USA
USA
1800 505 8311