Orbegozo TES 3650 Manual De Instrucciones página 34

TES 3650
Recommended separation distances between portable and mobile RF communications equipment and the Digital Blood
Pressure Monitor is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the Digital Blood Pressure Monitor can help prevent electromagnetic interference by maintaining a
minimum distance between portable and mobile RF communications equipment (transmitters) and the Digital Blood Pressure
Monitor as recommended below, according to the maximum output power of the communications equipment.
Output power of transmitter
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can
be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of
the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from
structures, objects and people.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected. Consumers should contact their local
authority or retailer for information concerning the correct disposal of their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage Directive
2006/95/EC and the requirements of the EMC directive 2004/108/EC.
Pressure Monitor.
Separation distance according to frequency of transmitter (m)
80 MHz to 800 MHz
d=1.167√P
0.117
0.369
1.167
3.689
11.667
80 MHz to 800 MHz
d=2.333√P
0.233
0.738
2.333
7.379
23.333
34