Indications For Use; Contraindications; Warnings - Cavitron Prophy-Jet Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 55
SECTION 1:

Indications For Use

The Cavitron
Prophy-Jet
®
®
is designed for use in general prophylaxis and periodontal
treatments and other areas of operative dentistry. It can also
be used for:
Stain Removal,
Prophylaxis of orthodontic patients,
Preparing tooth surfaces prior to bonding and sealant
procedures, and
Implant Debridement
SECTION 2:

Contraindications

Cavitron
Prophy-Jet
®
®
Sodium Bicarbonate powder. Therefore, this powder is
not recommended for patients on a sodium restricted
diet. Cavitron
JET-Fresh Prophy Powder is a sodium
®
free powder and can be used on patients who are on
sodium restricted diets.
Patients who have severe respiratory illness should
consult their physician before undergoing air polishing
prophylaxis procedures. Use is not recommended for
patients with known allergies to the components of
Cavitron Brand Prophy Powders.
SECTION 3: Warnings
The use of High Volume Saliva Evacuation to reduce
the quantity of aerosols released during treatment is
highly recommended.
Prior to beginning treatment, patients should rinse with
an antimicrobial such as Chlorhexidine Gluconate 0.12%.
Rinsing with an antimicrobial reduces the chance of
infection and reduces the number of microorganisms
released in the form of aerosols during treatment.
It is the responsibility of the Dental Healthcare
Professional to determine the appropriate uses of this
product and to understand:
– the health of each patient,
– the dental procedures being undertaken,
– and applicable industry and governmental agency
recommendations for infection control in dental
healthcare settings,
– requirements, and regulations for safe practice of
dentistry; and
– these Directions for Use in their entirety, including
Section 4 Precautions, Section 6 Infection Control, and
Section 10 System Care.
Where asepsis is required or deemed appropriate in
Air Polishing Prophylaxis System
Prophy Powder is a water-soluble
the best professional judgment of the Dental Healthcare
Professional, this product should not be used.
Failure to follow properly validated sterilization processes
and approved aseptic techniques for Cavitron inserts
may result in cross contamination.
Do not direct the air polishing stream at soft tissue or
into the sulcus. Tissue emphysema has been reportedly
caused when the air/water/powder stream was directed
at the soft tissue or into the sulcus. If tissue emphysema
occurs, consult a healthcare professional.
Insufficient water flow could result in elevated water
and air polishing insert nozzle temperature. When
operated at the input water temperature specified in the
Water Line Requirements Section 7.1 and with sufficient
water flow, the water and air polishing insert nozzle
temperature should not exceed 50
follow recommendations for environmental operating
conditions, including input water temperature, could
result in discomfort to patients or users. If temperature
is elevated, increase water flow. If temperature remains
elevated, discontinue use.
Empty the air polishing powder bowl at the end of the
day to prevent "caking" of the powder and clogging of
the lines and JET Air Polishing insert nozzle. Residual
prophy powder in threads of the bowl and cap can result
in excessive wear and disengagement of the cap during
unit operation. Be sure to clean threads regularly as per
Section 10 System Care. Check o-ring and threads on
powder bowl cap and replace if worn.
During boil-water advisories, this product should not
be operated as an open water system (e.g. connected
to a public water system). A Dental Healthcare
Professional should disconnect the system from the
central water source. The Cavitron DualSelect system
can be attached to this unit and operated as a closed
system until the advisory is cancelled. When the
advisory is cancelled, flush all incoming waterlines
from the public water system (e.g. faucets, waterlines
and dental equipment) in accordance with the
manufacturer's instructions for a minimum of 5 minutes.
Per FCC Part 15.21, changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate
this equipment.
This portable transmitter with its antenna complies with
FCC/IC RF exposure limits for general population /
uncontrolled exposure.
This Device complies with Industry Canada License-
exempt RSS standard(s). Operation is subject to the
following two conditions: 1) this device may not cause
interference, and 2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
7
o
o
C (122
F). Failure to

Publicidad

Tabla de contenido
loading

Tabla de contenido