Specific Safety Rules For Random Orbital Sanders - Genesis GROS2304 Manual Del Operario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in
Canada) to indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY RULES FOR RANDOM ORBITAL
SANDERS
WARning:
(gAinED FROM REPEATED USE) REPLACE STRiCT ADHEREnCE TO
PRODUCT SAFETY RULES. if you use this tool unsafely or incorrectly, you can
suffer serious personal injury!
• Always hold the tool firmly in your hands before switching the tool
"On".
The reaction to the torque of the motor as it accelerates to full speed may cause the tool
to twist.
• Do not leave the tool running.
• This tool has not been waterproofed,
surfaces.
• Ventilate your work area adequately
• Wear eye and hearing protection.
unless otherwise specified, everyday glasses provide only limited impact resistance, they are not
safety glasses. use only certified safety equipment; eye protection equipment should comply with
ANSI z87.1 standards. Protective hearing equipment should comply with ANSI s3.19 standards.
• Protect your lungs.
will reduce the risk of personal injury.
SAFETY RULES FOR PAINT REMOVAL
WARning:
peelings, residue, and vapors of paint may contain lead, which is poisonous.
Exposure to even low levels of lead can cause irreversible brain and nervous
system damage. Young and unborn children are particularly vulnerable.
Before beginning any paint removal process you should determine whether the paint you are removing
contains lead. This can be done by your local health department or by a professional who uses a paint
analyzer to check for lead.
5" Random Orbital Sander
Operator's Manual
50 Feet
75 Feet
18
18
18
16
14
12
10
DO nOT LET COMFORT OR FAMiLiARiTY WiTH PRODUCT
Operate the tool only when hand-held.
Wear a face or dust mask if the operation is dusty. following this rule
Extreme care should be taken when removing paint. The
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
so do not use water on the workpiece
when you perform sanding operations.
Always use safety glasses with side shields.
GROS2304
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6

Publicidad

Tabla de contenido
loading

Tabla de contenido