Positioning And Connection - Isotherm DIVINO Manual De Instrucciones

Manuale Istruzioni Cantina "DIVINO"
INSTALLATION

Positioning and connection

Unpacking
1. Immediately un pack the device and check
that it has not been damaged during its tran
sport. If it is damaged, do not connect it and
contact the retailer.
2. Remove the protections and adesive with
caution, open the door and check the integrity
of the various components.
3. Pull out the electricval power supplì cable.
Positioning the device
1. position the device in a properly ventilated
environment, not humid and with open space
(avoid closed wall wardrobes).
2. position the device far from heat sources.
3. Comply to the minimum distances between
the device and the compartment where i twill
be positioned, to ensure perfect ventilation to
the device. See figures DIVINO35 and
DIVINO23.
Electrical connection
After its transport, position the device upright and
wait at least 3 hours before connecting it to the
electrical system. Before inserting the plug in the
socket, make sure that:
the socket has a grounding connection and is
•
up to norm of law;
the socket can support the maximum power
•
load of the machine, as indicated in the
Technical Data chart or on the characteristics
plate on the lower right )see Description of
the device);
the power supply voltage is included in the
•
values pointed out in the Technical Data chart
or on the characteristics plate on the lower
right (see Description of the device);
the socket is compatible with the plug of the
•
device. If it is not, replace the socket or plug;
do not use multiple extensions.
8