Polar CK640 Manual De Instrucciones página 7

Insert the food probe
• Before selecting which cycle to use, the probe must be inserted into the food. This allows the internal
temperature of the food to be measured.
• It is important that the probe is correctly connected to the unit.
Note: To prevent bacterial contamination or contamination of any other
biological nature, the needle probe must be disinfected after use.
Control Panel
Timed
Chilling LED
Set-Temperature
Chilling LED
Storage LED
In the "on" state, during normal operation, the display shows:
• the amount of time remaining for a timed blast chilling operation, if this is ongoing
• the temperature measured by the pin probe if a set-temperature chilling operation is ongoing
• the temperature of the cabinet, if storage is ongoing.
In "stand-by" mode, during normal operation, the display shows the temperature of the cabinet for ½
second every 3 seconds.
Signals
LED
Timed Chilling LED
• If on and the LED
• If on and the LED
• If flashing, a timed chilling and storage cycle will have been selected
Set-temperature chilling LED
• If on and the LED
• If on and the LED
be ongoing
• If flashing, a set temperature chilling and storage cycle will have been selected
CK640_ML_A5_v4_20200728.indb 7 CK640_ML_A5_v4_20200728.indb 7
Alarm LED Minute LED
Message
is off, a timed chilling operation is ongoing
is also on, a post timed-chilling storage operation is ongoing
is off, a set-temperature chilling storage operation is ongoing
is also on, a post set-temperature chilling storage operation will
UK
Degree
Celsius LED
Degree
Fahrenheit LED
7
2020/7/28 17:38 2020/7/28 17:38