Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TO CHANGE
ENGINE
OIL
NOTE:
Before tipping
lawn mower to drain
oil, empty fuel tank by running
engine until
fuel tank is empty.
1. Disconnect
spark plug wire from spark
plug and place wire where
it cannot
come in contact
with plug.
2.
Remove
engine oil cap; lay aside on a
clean surface.
3. Tip lawn mower on its side as shown
and drain oil into a suitable
container.
Rock lawn mower back and forth to re-
move any oil trapped
inside of engine.
.
Install cartridge,
then replace cover
making sure the tabs are aligned
with
the slots in the back plate. Fasten
screw securely.
Back plate
/
C
Slot
Cover
,,u_
Cover
tab
®
MUFFLER
Inspect and replace
corroded
muffler
as it
could create a fire hazard and/or
damage.
4. Wipe off any spilled
oil from lawn
mower or side of engine.
5. Slowly pour oil down the oil fill spout,
stopping
every few ounces to check the
oil level with the dipstick.
6. Stop adding oil when you reach the
FULL mark on the dipstick.
Wait a
minute to allow oil to settle.
7. Continue
adding small amounts
of oil,
rechecking
the dipstick
until oil level
settles at FULL.
DO NOT overfill,
or
engine
will smoke
heavily from the muf-
fler on startup.
8. Always
be sure to retighten
oil dipstick
before starting
engine.
9.
Reconnect
spark plug wire to plug.
AIR FILTER
Your engine will not run properly
and may
be damaged
by using a dirty air filter.
Replace the air filter cartridge
every 100
hours of operation
or every season,
which-
ever occurs first.
Service
air cleaner
more
often under dusty conditions.
TO CLEAN
AIR FILTER
1. Loosen screw and tilt cover to remove.
2. Carefully
remove
cartridge.
3. Clean by gently tapping
on a flat sur-
face. If very dirty, replace
cartridge.
_iLCAUTION:
Petroleum
solvents,
such as
kerosene,
are not to be used to clean car-
tridge. They may cause deterioration
of the
cartridge.
Do not oil cartridge.
Do not use
pressurized
air to clean or dry cartridge.
13
SPARK
PLUG
Replace
spark plug at the beginning
of
each mowing season
or after every 100
hours of operation,
whichever
occurs
first.
Spark plug type and gap setting
are shown
in the "PRODUCT
SPECIFIC-
ATIONS"
section
of this manual.
CLEANING
IMPORTANT:
For best performance,
keep mower housing
free of built-grass
and trash.
Clean the underside
of your
mower after each use.
_;kCAUTION:
Disconnect
spark plug wire
from spark plug and place wire where
it
cannot come in contact with plug.
• Clean the underside
of your lawn
mower by scraping
to remove build-up
of grass and trash.
• Clean engine often to keep trash from
accumulating.
A dogged
engine runs
hotter and shortens
engine life.
• Keep finished
surfaces
and wheels free
of all gasoline,
oil, etc.
• We do not recommend
using a garden
hose to clean lawn mower unless the
electrical
system,
muffler, air filter and
carburetor
are covered
to keep water
out.
Water in engine can result in short-
ened engine life.
÷
388111-es-412691_r0indd
13
4_
2/23/2007
10:59:50AM
Publicidad
Tabla de contenido
