Publicidad
Idiomas disponibles
Idiomas disponibles
®
_, WARNING:
To avoid serious
injury,
before performing
any service
and
adjustments:
1. Release
control bar and stop engine.
2.
Make sure the blade and all moving
parts have completely
stopped.
3.
Disconnect
spark plug wire from spark
plug and place wire where
it cannot
come in contact
with plug.
LAWN
MOWER
TO ADJUST
CUTTING
HEIGHT
See "TO ADJUST
CUTTING
HEIGHT"
in
the Operation
section
of this manual.
REAR
DEFLECTOR
The rear deflector,
attached
between
the
rear wheels
of your mower, is provided
to
minimize
the possibility
that objects
will
be thrown out of the rear of the mower
into the operator
mowing position.
If the
deflector
becomes
damaged,
it should be
replaced.
TO ADJUST
HANDLE
The handle can be mounted
in a high or
low position.
The mounting
holes in the
bottom
of lower handle are off center for
raising
or lowering
the handle.
1. Remove
upper handle and all wire
tie(s) securing
cable(s) to lower handle.
2.
Remove
hairpin cotters from lower
handle bracket
mounting
pin.
3. Squeeze
lower handle in to remove
it
from mounting
pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeeze
lower handle in and position
holes onto mounting
pins on handle
bracket.
6.
Reassemble
upper handle and all
parts removed
from lower handle.
SQUEEZE
TO ADJ UST
Lower handle -'-'-'_
:0=
Mounting pin --_
Handle
/
""bracket
Hairpin cotter
Mowing
r-<_
Mowing
iposition
,
position
Hairpin
\\_._..44_,
"_
\
cotter-'_
_
I _....Handle
Mounting,,q _"
_
I_J
bracket
pin
LOW POSITION
HIGH POSITION
/
/
/
!
\
Lower
handle
ROTATE
ENGINE
ENGINE
SPEED
Your engine speed
has been factory set.
Do not attempt
to increase
engine speed
or it may result in personal
injury.
If you
believe
that engine
is running too fast or
too slow, take your mower to a Sears or
other qualified
service
center for repair
and adjustment.
CARBURETOR
Your carburetor
is not adjustable.
If your
engine does not operate properly
due to sus-
pected carburetor
problems,
take your lawn
mower to a Sears or other qualified
service
center for repair and/or adjustment.
IMPORTANT:
Never tamper
with the
engine governor,
which is factory
set
for proper engine speed.
Overspeeding
the engine above the factory
high speed
setting can be dangerous.
If you think
the engine-governed
high speed
needs
adjusting,
contact
a Sears or other
qualified
service
center, which has proper
equipment
and experience
to make any
necessary
adjustments.
14
÷
388111-es-412591_r0indd
14
4_
2/23/2007
10:59:51 AM
Publicidad
