Installation - Musical Fidelity M6x ViNYL Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

Introduction
This unit will deliver the ultimate performance
possible from any phono source.
Cleaning
Before cleaning the unit, switch off power at the
mains switch and remove the mains plug from the
wall socket. Clean the cabinet and remote-control
unit using a moist cloth. Using solvents, white
spirit or thinners is not advised, as they could
damage the surface finish.
Installation
Position the M6x ViNYL on a stable, horizontal
surface where there is no risk of it being
knocked or subjected to vibration such as from
loudspeakers.
Power Connections
The M6x ViNYL is supplied with a standard IEC
mains cable which plugs into the IEC socket at the
back of the unit.
Audio Output Connections
RCA audio outputs: Use good quality RCA phono
audio cables (fully connected signal and ground),
for optimum signal transfer.
XLR audio outputs : Use good quality XLR audio
cables (fully connected hot and cold signals and
ground), for absolute optimum signal transfer.
Interconnects
If necessary, please refer to the dealer who can
advise on quality cables for any setup. Musical
Fidelity
does
not
manufacturer's cables.
Cartridge characteristics
For setting the various loading characteristics, the
cartridge manufacturer's data sheets or setup
information should be consulted.
In a lot of cases the settings are not critical, and
may even be changed to suit personal preference,
if any audible differences are apparent.
No damage will occur to an "incorrectly" loaded
cartridge; at very worse a slightly impaired or
nonoptimal frequency response and/or slightly
increased distortion, both most likely to be
inaudible, may result.
endorse
any
other
5

Publicidad

Tabla de contenido
loading

Productos relacionados para Musical Fidelity M6x ViNYL

Tabla de contenido