Pcm Output Gain Setting; Analog Output Setting; Dimmer Setting; Automatic Display Darkening Setting - Esoteric N-01XD Manual Del Usuario

PCM output gain setting

PCMG>***
Use this to set the gain for PCM signal playback. This can be used to
reduce the volume difference between PCM and DSD signal playback.
Set it as necessary.
o By default, USB and NET are set to LOW and other inputs are set to
FULL.
o This setting can be made for each input.
FULL
The gain is not adjusted.
LOW
The output level of PCM signals during full scale 0dB playback and
the output level of DSD signals during 0dB playback are the same.
Use when the volume of PCM signals during playback seem loud
compared to DSD signals.

Analog output setting

AOUT>***
Use this to select the analog output connector to be used.
o By default, the setting is XLR2.
XLR2
Analog audio signals are output through the XLR connectors with
pin 2 HOT.
XLR3
Analog audio signals are output through the XLR connectors with
pin 3 HOT.
RCA
Analog audio signals are output through the RCA connectors.
ESLA
Analog audio signals are output as ES-LINK Analog (ESL-A)
through the XLR connectors.
o These connections use ordinary XLR cables, but the signals are
transmitted in a unique format, so this setting should only be
used with compatible devices.
o See page 10 for more about ES-LINK Analog (ESL-A).

Dimmer setting

DIMMER>***
Use this to adjust the brightness of the unit's display.
By default, the setting is 2.
DIMMER>3
c
DIMMER>2 (normal brightness)
c
DIMMER>1
c
DIMMER>0 (off )
o Even when set to DIMMER>1 or DIMMER>0, setting menus and
error messages will be shown with normal brightness (DIMMER>2).

Automatic display darkening setting

DPaOFF>***
Use this to set the display to darken automatically.
o By default, the setting is ON.
o If the OEL display is left on with the same indication for a long time,
brightness irregularities can occur. For this reason, we recommend
that you set the automatic display darkening function to ON.
ON
If no operation is conducted for ten minutes, the display automati-
cally turns off.
OFF
The display will not turn off automatically.
o If no operation is conducted for ten minutes, the display will
dim to DIMMER>1 brightness to protect it from excessive wear.
17