Analog Output Setting; Automatic Display Darkening Setting; Automatic Power Saving Setting; Digital Output Setting - Esoteric N-05 Manual Del Usuario

Analog output setting

Display (AOUT>***)
XLR2
Analog audio signals are output through the XLR connectors with
pin 2 HOT.
XLR3
Analog audio signals are output through the XLR connectors with
pin 3 HOT.
RCA
Analog audio signals are output through the RCA connectors.
OFF
Analog audio is not output and the D/A converter circuit stops
operating.

Digital output setting

Display (DOUT>***)
OFF
Digital output is disabled.
ON
Digital output is enabled.
o Signals are output according to the upconversion setting and the
input source signals.
o Digital output is possible at resolutions up to 192kHz PCM and
2.8MHz DSD (DoP).
If these limits are exceeded because of the upconversion setting
or input source signals, no signal will be output.
o When UPCONV> is set to FIX (fixed output format mode), digital
signals will be output according to the FIX> (fixed output format)
setting regardless of the format of the input source signals. This
allows audio files in a playlist to all be output digitally even if they
have various different sampling frequencies.

Automatic display darkening setting

Display (DPaOFF>***)
ON
The display will automatically darken after playback remains
stopped for 30 minutes.
OFF
The display will not automatically darken.
o We recommend setting this to ON because display brightness
irregularities might occur if the same information is shown with-
out change for a long time.

Automatic power saving setting

Display (APS>***)
o By default, the setting is 30m.
When the input source is RCA1, RCA2, OPT or USB, the unit will turn
off automatically if the set amount of time passes without being able
to lock an input signal from the selected input source.
o The input sources that are not selected have no effect on auto-
matic power saving.
30m
30 minutes
60m
60 minutes
90m
90 minutes
120m
120 minutes
OFF
The automatic power saving function is disabled.
17