System Settings - Bosch Coach MediaRouter Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
Settings
Network key / Re-enter key
f
The WLAN data traffic (see previous point) is
encrypted with the help of the key. The key must be
supplied by the end device when establishing the
WLAN connection. The factory-set key is given on
the underneath of the device.
You can enter an individual key of up to 63 charac-
ters in length.
f
IP
Enter the network address (IP address) that allows
access to the device or to its user interface here.
The factory setting for the IP address of the device
is:
192.168.1.1
f
Subnet mask
Enter the subnet mask for the WLAN network of the
device here.
The subnet mask specifies what range of IP
addresses is available for end devices in the WLAN
network of the device.
The factory setting for the subnet mask of the
device is: 255.255.255.0
Cascading
Note:
You can extend the range of the WLAN network
by cascading a number of devices.
f Choose the Settings/Cascading menu item.
You will find these settings in the Cascading menu:
Enable Cascading
f
Set whether cascading is active or inactive here.
f
Cascading Role
Set whether the device is to operate as a base
station (Master) or repeater (Slave) here.
Robert Bosch Car Multimedia GmbH

System settings

f Choose the Settings/System menu item.
You will find these settings in the Systemeinstellungen
menu:
New password / Repeat password
f
Enter a new password here for access to the Setting
menu, or to the entire user interface (see next
point).
The password set at the factory is "admin".
Password protection
f
Set here whether the password protection is only to
apply to the Settings menu (option: Settings only)
or to the entire user interface of the device (option
All pages).
Shut-off delay
f
Enter how long the device should remain switched
on and active after the vehicle ignition has been
switched off here.
Homepage
f
Specify the start page for the user interface here
(option: Overview or Position).
Theft protection by email / SMS
f
You can activate or deactivate theft protection by
email or SMS here. If theft protection is active, then
an email or a text message with the position of the
device is sent every time it is switched on or off.
Enter the email address or telephone number to
which the messages should be sent when you
activate theft protection.
Reset device
f
You can restart the device here (option: System
en | 19
7 620 320 029 | 06.2018

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

7 620 320 029

Tabla de contenido