Maintaining And Cleaning The Power Supply Unit - Dometic SMP 301-02 Instrucciones De Montaje

SMP301-02/-03
7.2 Replacing the plug-in fuses
I
NOTE
The positioning of the plug-in fuses is used to configure manufacturer-
specific functions.
When replacing a plug-in fuse, take care to fit the replacement in the
same place. Malfunctions may occur otherwise.
➤ Disconnect all consumer units from the power supply unit.
➤ Disconnect the power supply unit from the power supply.
➤ Press the two tabs (fig. 4 1, page 5) in the direction indicated by the arrows and
lift the cover off (fig. 4 2, page 5).
➤ Only replace plug-in fuses which have blown with new plug-in fuses of the type
"ATO Type – LITTLEFUSE" and the same rating.
➤ Re-attach the cover to the power supply unit.
➤ Put the power supply unit back into operation.
➤ If the plug-in fuse is tripped again, please contact the manufacturer's branch in
your country (see the back of the instruction manual for the addresses) or your
retailer.
8 Maintaining and cleaning the power
supply unit
A
NOTICE!
Do not use any sharp or hard objects for cleaning since they may
damage the device.
➤ Clean the power supply unit using a damp cloth as required.
EN

Maintaining and cleaning the power supply unit

17