Ring Gear Drill Chuck (Article 24152); Inserting The Drill Chuck (Fig. 15); Multiple Range Er 11 Collets (Article 24154); Inserting The Collets (Fig. 16) - Proxxon FD 150/E Manual De Uso

Ring gear drill chuck (Article 24152)

Drills with sizes 0.5 to 6.5 mm can be clamped in the drill chuck
to manufacture holes on the plane side.

Inserting the drill chuck (Fig. 15)

1. Remove the travelling lathe centre from the quill as explained
at "Working with the tailstock".
2. Appropriately clean off the grease and dirt from the cone of
the chuck 1 and quill 2.
3. Insert the collar into the quill and firmly push on the drill
chuck.
4. Clamp the drill.
5. The complete tailstock 3 can now be moved up to the work-
piece to be machined after the clamping lever 4 has been re-
leased. Then tighten clamping screw 4.
6. Turn the handwheel 5 to move the drill up to the workpiece.
7. Switch on the machine and turn the handwheel 5 to lower the
drill to the required depth in the workpiece.
A tip: If the drill is set down very lightly, the scale ring 6 can be
"zeroised". This enables the manufacture of drill holes with a de-
fined depth by observing the scale markings and counting the
handwheel revolutions during infeed: One revolution will tra-
verse the drill by 1 mm.

Multiple range ER 11 collets (Article 24154)

The collets are particularly suitable for machining round parts
with great precision. The true running accuracy is considerably
higher here than when working with a jaw chuck.
It is possible to use workpieces with diameters of up to 0.5 mm
below the nominal diameter of the collet.
Never tighten the swivel nut if no workpiece was inserted.

Inserting the collets (Fig. 16)

1. Use the wrench 1 supplied with the machine to hold the main
spindle 2 at the provided flat surfaces and screw off the chuck
3 from the main spindle.
2. Thoroughly clean the fit for the collet holding fixture 4 in the
main spindle.
3. Utilise the collet 5 and slightly unscrew the swivel nut 6.
4. Insert the appropriate workpiece in the collet and tighten the
swivel nuts 6 with the wrench 7 provided with the collet set.
- 24 -
Caution!
Caution:

Disposal:

Do not dispose of the device in the household waste! The device
contains materials that can be recycled. If you have questions
concerning this topic, please contact your municipal disposal
company or other appropriate municipal institutions.

EC Declaration of Conformity

Name and address:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation:
Article No.:
In sole responsibility, we declare that this product conforms to
the following directives and normative documents:
EU EMC Directive
EU Machinery Directive
Date: 26.09.2012
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
The CE document authorized agent is identical with the signatory.
FD 150/E
24150
2004/108/EC
DIN EN 55014-1 / 02.2010
DIN EN 55014-2 / 06.2009
DIN EN 61000-3-2 / 06.2011
DIN EN 61000-3-3 / 06.2009
2006/42/EC
DIN EN 61029-1 / 01.2010