General Description - GYS Toparc TPT 40 Manual De Uso

ELECTRIC SAFETY
An electric shock can be a source of a direct or indirect, or even fatal, serious accident.
Never touch the live parts of the torch as it is connected to the cutting circuit.
Do not touch the torch and the ground clamp at the same time.
Always use dry, well-maintained clothing to isolate yourself from the cutting circuit. Wear insulating shoes, no matter where you work.
PRECAUTION FOR USE
Never wrap the cutting leads around your body.
Do not use the cables or torch to move the machine.
The torch must be fully uncoiled to prevent overheating.
Switch off the generator after the torch is cooled and before each maintenance and before replacing or control wearing parts.
Regularly check the condition of the torch. If damaged, the torch must be replaced.

GENERAL DESCRIPTION

SPECIFICATIONS
The TPT 40 torches are intended to the
SET UP
Compatibility with cutting power generator
Designation
Reference
Length
Striking voltage
Maximal rated current
Operating factor to 40°C
Gas type
Torch cooling mode
Recomended air pressure / air flow
Room temperature range for cutting
Trigger switch characteristics
Switch characteristic (trigger)
Applied standard
INSTALLATION
TORCH CONNECTION REQUIREMENT
The generator must previsouly be powered off.
Insert the torch's connector (A) in the female compartment (E) and screw the B part. Be careful to tighten the torch.
To remove the torch, unscrew in the same manner as above.
TPT 40
manual PLASMA cutting process.
60%
Torch connector
1
9
8 2
Pins 1 and 2 : Switch
Pins 4 and 6 : Pilot arc
3
7
4
6
5
EN
CUTTER 30 FV
EASYCUT 40
CUTTER 45 CT
TPT 40
060753
4 m
500 V max
40 A
40 A
air
air
5 bars - 100 l/min
-10 -> +40°C
-10 -> +55°C
0.6 A / 125 V DC
0.3 A / 250 V DC
EN60974-7: 2013
7