General Description - GYS GYSPACK 660 Manual De Instrucciones

Translation of the original instructions
Disposal:
• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.
• The battery fitted in this device is recyclable. Please proceed ac-
cording to the applicable recycling regulations.
• The battery must be removed from the device before the latter is
discarded.
• The device must absolutely be disconnected from the power sup-
ply network before removing the battery.

GENERAL DESCRIPTION

The high performance internal battery allows the GYSPACK 660 / 750 to serve 4 functions:
- Test battery
- Instant Start from vehicle equipped with 12V Lead battery (Gel or Liquid electrolyte).
- 12 V DC power supply, to supply light Spot, TV, tools, etc...
- Light
CHARGE THE INTERNAL BATTERY
Before using the device turn the knob to OFF.
Charge the device once bought and after each use with the charger provided.
Do not use another charger than the one provided with the device.
This device is delivered with an automatic charger (for the internal battery), double insulated with a floating system
enabling to keep the internal battery charged to 100% unsupervised.
To charge the internal battery :
• Place the device vertically during charging to avoid acid leaking and damaging the internal battery.
• Connect the charger to a 230V power supply, The green LED lights and the cigarette lighter LED lights red. Connect
the cigarette lighter plug into the side of the device.
• Turn the knob to 12V to start charging. If the knob stays is on OFF or 24V it will not charge.
• The charger LED turns red when the cigarette lighter plug is connected. The charge is in progress.
• The device is charged once this LED turns back to green.
STARTING A VEHICLE
Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information
and a possible inability to restart.
The booster must be stored in a vertical position. Any other storage position should only be temporary.
In order to use the GYSPACK 660 / 750 as a starter, follow these steps:
• Disconnect the GYSPACK 660 / 750 from the mains. Turn the vehicle ignition key to OFF.
• Position the switch «OFF».
• When the battery negative terminal is connected to the vehicle chassis:
- Connect the red clamp to the positive terminal of the battery.
- Connect the black clamp to the vehicle chassis, ensure it is not close to fuel lines and the battery.
• Some vehicles have the battery positive terminal connected to the chassis, in this case:
- Connect the black clamp to the negative terminal of the battery.
- Connect the red clamp to the vehicle chassis, ensure it is not close to fuel lines and battery.
• Position the switch «ON».
GYSPACK 660 / 750
The cables must not be pinched or in contact with hot or sharp surfaces.
EN
11