General Description; Power Supply - GYS START 200 Manual De Instrucciones

Translation of the original instructions
Disposal:
• This product should be disposed of at an appropriate recycling

GENERAL DESCRIPTION

The START range is designed to charge and start lead-acid batteries, 12V (6 elements) and 24V (12 elements) :

POWER SUPPLY

Check that the power supply and its protection (fuse and/or circuit breaker) are compatible with the current needed by
the machine. The device must be positioned so that the socket is always accessible.
The machine must be connected to a single phase socket (230 V) WITH earth protected by a 16A circuit breaker.
CONNECTION AND DISCONNECTION
IMPORTANT ! Before any connection to a vehicle battery, make sure that the booster isn't connected to the mains and
that the booster's switch is set to OFF. Also, check the battery polarity.
Warning : the cables must not be kinked or in contact with hot or sharp surfaces.
• Disconnect any electronic system from the battery during the charge (do not charge the battery when it's connectd
to the vehicle).
Start and charge a battery in-situ :
In the event that the negative terminal is plugged onto the car's chassis :
• Connect the red clamp to the battery's positive terminal.
• Connect the black clamp to the vehicle's chassis, make sure it is a safe distance from the battery and the fuel/exhaust
pipe.
• Connect the device to the mains.
• After use, set the switch to OFF (if applicable), disconnect the charger from the mains then remove the black clamp,
followed by the red clamp.
Some vehicles have the positive terminal plugged onto the car chassis, in this event :
• Connect the black clamp to the battery's negative terminal.
• Connect the red clamp to the vehicle's chassis, make sure it is a safe distance from the battery and the fuel/exhaust
pipe (any combustible piping).
• Connect the device to the mains.
• After use, set the switch to OFF (for the START 300), disconnect the charger from the mains then remove the red
clamp, followed by the black clamp.
Charging a battery when disconnected from the vehicle :
• Connect the red clamp to the battery's positive terminal and the black clamp to the battery's negative terminal.
• After use, set the switch to OFF (for the START 300), disconnect the charger from the mains then remove the red
clamp, followed by the black clamp.
USE IN CHARGING MODE
Preliminary precautions
• Choose a sheltered and well ventilated area, or a dedicated battery charging area.
• Remove the battery caps (if applicable) and make sure that the liquid level (electrolyte) is sufficient. If not, add
demineralised water and carefully clean the battery lugs and terminals.
• Check that the battery capacity (Ampere hour Ah) and the voltage (Volt V) are compatible with your charger.
• We recommend disconnecting of any electronic system battery while charging (do not charge the battery when
connected to the vehicle). Risk of vehicle electronics damage.
10
START 200 / 300
facility. Do not dispose of in domestic waste.
Start 200
Start 300
Charging capacity
53 - 240 Ah
38 - 300 Ah
Starting capacity
35 - 80 Ah
35 - 100 Ah
EN