Trouble-Shooting; Alarm Management - Frigomat Titan Serie Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

7 TROUBLE-SHOOTING

7.1 ALARMS MANAGEMENT
The "OMEGA" electronic card is a powerful control logic unit which signals possible
machine troubles by means of alphanumeric messages visualised on the display; the
technician shall understand them to quickly find the reason of this trouble.
MESSAGE
EME
EMERGENCY
TER
MOTOR
THERMAL
CUTOUT ALARM
When the machine is started up, the microprocessor checks
EPO
STORED DATA
ALARM
EPI
MEMORY ALARM
LI
POWER SUPPLY
ALARM
OUT
USCITE MODULE
ALARM
TA
TA ALARM
UTA
TA MICRO-
PROCESSOR
ALARM
25 - ENGLISH
DESCRIPTION
The door is open or the safety grid on the hopper is not
completely lowered.
An intermittent beep is released.
When a motor thermal cutout is triggered, it is followed by
the blinking of the led TER and by the release of an
intermittent beep.
the data stored in the EPROM memory: if this data are not
correct EPO will appear on the display, followed by the
release of an intermittent beep.
If, during normal functioning, the memory is not
acknowledged, EPI will appear on the display, followed by
the release of an intermittent beep.
If, during normal functioning, the voltage is too low, LI will
appear on the display, followed by the release of an
intermittent beep.
If, during normal functioning, the output control module is
faulty or if it is not acknowledged, OUT will appear on the
display, followed by the release of an intermittent beep.
If, during normal functioning, an anomaly of the current
transformer occurs, TA will appear on the display, followed
by the release of an intermittent beep.
If, during normal functioning, an anomaly of the
microprocessor controlling the consistency calibration
occurs, UTA will appear on the display, followed by the
release of an intermittent beep.
REMEDIES
Make sure that the door
is closed and the safety
grid on the hopper is
lowered.
After checking the
machine, press STOP to
restore correct
functioning.
Send for a technician.
Send for a technician.
Check mains voltage
and machine power
supply.
Send for a technician.
Send for a technician.
Send for a technician.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Titan 1Titan 2Titan 3s

Tabla de contenido