Fagor PBP5VI502FTB5 Manual De Instrucciones página 60

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
Warm up function
The warm up function keeps stable temperature of food on a heating zone. The selected heating
zone is set to low heating power. This function will help you enjoy warm food, ready for serving
at your convenience, that will not change taste or stick to the bottom of the pot. This function
can be used to melt butter, chocolate, etc.
To use this function correctly, please provide a pot with a flat bottom so that its temperature
can be accurately measured by the detector in the heating zone. The warm up function can be
activated on each zone. For microbiological reasons, it is not advisable to keep food warm for too
long. Consequently, when this function is used, the panel sensor will switch off after two hours.
You can set 3 temperature levels on the heating zone: 42°C, 70°C and 94°C.
Activation of the warm up function should be performed as follows:
● press the warm up function sensor (12), which is signalled by switching on of the first LED
– this means choosing the heating level of 42°C.
● press the warm up function sensor (12) again, which is signalled by switching on of the
second LED – this means choosing the heating level of 70°C.
● press the warm up function sensor (12) for the third time, which is signalled by switching
on of both LEDs – this means choosing the heating level of 94°C.
● then, having selected one of the heating levels, press sensor (+) (2) for a specific heating
zone, which is signalled by the appearance on the display (4) of a symbol assigned to a
given level (
The warm up function can be deactivated at any time by simultaneous pressing of sensor
(+) (2) and sensor (-) (3), or by reducing power to level (0) using sensor (-) (3).
Stop'n go function „II"
This function works like a standard pause. Using it, you can at any time suspend the hob ope-
ration and return to previous settings.
To activate the stop'n go function at least one
heating zone has to be on.
Then press the sensor (11). On all indicators
of heating zones (4) symbol „II" comes on, up
and above the sensor (11) – the signal LED
comes on.
In order to deactivate the stop'n go function
you have to press the sensor again (11), the
signal LED begins to blink; then press any
sensor (2). Settings light up on the indicators
of heating zones (4) that were set before the
activation of the stop'n go function.
60
) (
) (
).
11
4
10
2
1
3
11
4
10
2
1
3

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

3if-zone95b4s

Tabla de contenido