Macro Flash; Caution; Battery Information - Dörr Combi TTL Flash Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2.2 Macro Flash

Autofocus Illumination
Macro Flash Tube right side
Fixing Clamp
Autofocus Illumination
Macro Flash Tube left side
Fixing Clamp

2.3 Caution!

Before using this flash unit, it is important to carefully read and follow these security instructions:
• Should this flash prove to be defective do not attempt to open the housing or to repair the flash yourself. This flash contains a
high voltage condenser. Take the flash unit to your local photo specialty shop or contact your local DÖRR service agent.
In case the flash housing is broken, do not touch the interior parts of the flash.
• This flash unit is a technical instrument of high precision which should be protected against shocks, dropping or other improper
handling.
• The flash unit is not water resistant. Rain and humidity may cause damages which are irreparable.
• Protect the flash unit from extreme temperatures as may occur in cars or in direct sun reflection. Avoid extreme temperature
changes.
• Never use aggressive cleansing agents such as benzine to clean this flash.

2.4 Battery Information

• Before inserting the batteries be sure that there is no dust in the battery compartment nor on the contacts.
• Always use 4 fresh batteries of the same type and brand (AA).
• Do not combine AA alkaline batteries with rechargeable batteries.
• Replace the batteries by fresh ones if the flash ready display doesn't light up within 30 seconds.
• Batteries develop their full capacity at a temperature of approximately 20°C/70°F. In order to achieve full performance at lower
temperatures, protect the flash unit against cold, for instance by carrying your equipment e.g. in a DÖRR ICEBREAKER backpack
which comes with an integrated thermal compartment with heat pack. Your batteries will perform at a maximum even at extremely
low temperatures.
• Never throw batteries into open fire or attempt to recharge batteries other than those made for this purpose (NiMH) due to danger
of explosion!
• Protect your environment by proper waste disposal of batteries after use.
10
Connection Socket
On/Off Switch for both Left & Right Macro Flash Tube
Main Connection Rings 58 and 72 mm

Publicidad

Tabla de contenido
loading

Tabla de contenido