Daewoo DTD 5500 Manual De Instrucciones página 36

keypad. The display will show the handset label you have entered and the handset will ring.
2) Once the handset answers the call, press * (star) key on the keypad of the base and the display will
change from "INTERCOM" to "CONFERENCE", and both the base and the cordless handset will be
connected to the external call.
3) When either the base or the handset hangs up, the other will still be connected to the external call.
Receiving a conference call
When you receive intercom ringing from a handset, answer the call and the display will show "INTERCOM".
Then wait for the handset to initiate the three-way conference call.
Adjust handset volume and hands
In on-hook state or during a call, user can adjust the handset volume by pressing VOL+/VOL-, there are 6
levels can be adjusted.
Adjust hands free speaker volume
In hands free state, user can adjust the speaker volume by pressing VOL+/VOL-, there are 5 levels can be
adjusted.
HANDSET SETTINGS: DECT PHONE
LCD Map
Icon
The antenna icon will always be shown on the LCD, it indicates for Signal strength, flashes
when registration to base is lost or when RSSI is low.
The icon will be displayed when the user has pressed
This icon will be displayed when the handset keypad is locked.
The alarm icon will be shown as steady on when the alarm is set.
The alarm icon will flash when the alarm is triggered.
The icon will be displayed when external ring set to off
The phonebook icon will be displayed when viewing the phonebook entries.
Displayed when a new voice message is received from the network
Displayed when the same missed call received more than one time
RPT
The icon will be displayed when a new call comes and hasn't been viewed yet.
NEW
When you press ∧ or ∨ key directly to scroll and review the numbers, it appears along with the
#
digit to indicate the sequence of the call.
Function
key.
36