Carburetor - EarthQuake MC440 Manual Del Operador

2. Unscrew oil drain screw and empty oil into suitable oil
container. (SEE FIGURE 3 on PAGE 10) Dispose of oil properly.
3. Reinsert drain screw and remove oil dipstick.
4. Fill with appropriate oil to "FULL" or top line of dipstick (SEE
FIGURE 3 on page 10).
5. Reinsert dipstick or oil fill cap and tighten.
SPARK PLUG
The recommended spark plug is a NGK CMR6A. For
maintenance and care of the spark plug go online to www.
getearthquake.com for instructions or call Earthquake
customer service.

CARBURETOR

Never tamper with factory setting of the carburetor.
COOLING FINS
Cooling fins, air inlets and linkages must be free from any debris
before each use.
AIR FILTER
Never run engine without air cleaner properly installed. Added
wear and engine failure may occur if air cleaner is not installed
on engine.
Service air cleaner every 3 months or after 20 hours of operation.
Clean filter daily in extremely dusty conditions.
Steps for Replacing and Cleaning Air Filter
1. Before removing the air filter cover, move the choke lever to
the CHOKE position.
2. To remove air filter cover, unscrew the cover bolt with a screw
driver and gently pop out the front latch tab. The cover then
can be slid off the back latch tabs and away from the engine.
SEE FIGURE 10
3. Remove the foam filter and fiber filter elements. Replace with
a new fiber filter and a new oiled foam filter (SEE FIGURE 11),
or clean the original foam and fiber filters with warm water
and mild soap. Remember to thoroughly oil the foam filter
with 30 or 40 weight motor oil and squeeze out any excess oil
before reinstalling it. Make sure to press the foam filter evenly
into place over the fiber filter to ensure that the foam is fully
seated into its sealed position.
4. Replace the air filter cover by first connecting the back latch tabs
then swinging the cover, making sure the foam filter block stays
fully seated and in its proper position, and connect the front latch
tab so that it is secured into place.
5. Screw the cover bolt back into place. Check that the cover is
securely attached by pulling slightly on the cover. If the cover
doesn't move when pulled, it is secure.
14
TO AVOID INJURY OR DEATH, NEVER SIPHON FUEL BY
MOUTH.
NEVER STORE CULTIVATOR WITH FUEL IN THE FUEL TANK
INSIDE AN ENCLOSED AREA OR BUILDING.
NOTICE
NEVER TWIST AIR FILTERS WHEN CLEANING. ALWAYS
PRESS.
BACK LATCH
TABS
FIGURE 10
AIR FILTER
COVER
COVER
BOLT
FIGURE 11
TRANSPORTING YOUR CULTIVATOR
1. After using the cultivator, and before transporting it in a truck
bed, check that the gas cap is screwed on (clockwise) tightly.
The gas cap will not leak during transporting if gas cap is tight.
Never transport engine inside an enclosed space within a
vehicle. Fuel or fuel vapors may ignite causing serious injury
or death.
2. If fuel is present in the fuel tank, transport in an open vehicle
in an upright position.
3. If an enclosed vehicle must be used, remove the fuel into an
approved red fuel container. DO NOT siphon by mouth.
4. Wipe away any spilled fuel from engine and cultivator. Allow
to dry.
5. Run the engine to use up the fuel in the carburetor and fuel
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
MC440 4-Cycle Cultivator
DANGER
AIR FILTER
COVER
FIBER FILTER
FOAM FILTER
ELEMENT
ELEMENT
Operator's Manual
FRONT
LATCH TAB