KREAFUNK bGEM Manual De Instrucciones página 15

Factory Reset
To reset the headphones, press and
hold the power button for about 5
seconds when in charging mode
and release it when the red and
blue LED light flashes simultane-
ously.
Remarks:
After a factory reset, the paired list
of earbuds will be deleted. When
you power on the earbuds and con-
nect them to a device again, they
will enter pairing mode automati-
cally on your device.
FAQs
1. What does it mean when red the
LED light flashes instead of blue
LED? The battery is low on power,
and needs to be recharged.
2. Why is the red LED light not
showing during charging?
a) Please make sure the charging
device is connected correctly
with the earbuds.
b) The battery has run completely
out of battery. Please charge
the battery for 30 minutes,
and then the red LED light will
show.
3. Why can't I hear the sound on
the headphones?
a) Make sure the volume is not too
low or muted.
b) Make sure the headphones are
connected correctly with the
device.
c) Make sure the distance
between the headphones
and the device is within the
accessible Bluetooth range.
4. Why does the "play / pause" +
"next / previous song" functions
not work on the touch buttons
when playing music?
Please check and make sure your
Bluetooth device supports AVRCP
(Audio/Video Remote Control
profile).
English
15