Before Use; What's In The Box; Precautions For Use; Names And Functions Of Parts (Display) - Esoteric G-02X Manual Del Usuario

Before use

What's in the box

Check to be sure the box includes all the supplied accessories shown
below. Please contact the store where you purchased this unit if
any of these accessories are missing or have been damaged during
transportation.
Power cord × 1
Felt pads × 3
Owner's manual (this document) × 1
Warranty card × 1

Precautions for use

o This unit is very heavy, so take care to avoid injury during installation.
o Do not install this unit in a location that could become hot. This
includes places that are exposed to direct sunlight or near a radia-
tor, heater, stove or other heating equipment. Moreover, do not
place it on top of an amplifier or other equipment that gener-
ates heat. Doing so could cause discoloration, deformation or
malfunction.
o When installing this unit, leave a little space (at least 20 cm or 8")
between it and walls and other devices in order to allow good
heat dissipation.
If you put it in a rack, take precautions to prevent overheating
by leaving at least 5 cm (2") open above the top of the unit and
at least 10 cm (4") open behind the unit. Failure to provide these
gaps could cause heat to build up inside and result in fire.
o Place the unit in a stable location near the audio system that you
will use with it.
o Do not move the unit during use.
o Be careful to avoid injury when moving the unit due to its weight.
Get someone to help you if necessary.
o The voltage supplied to the unit should match the voltage printed
on the rear panel. If you are in any doubt regarding this matter,
consult an electrician.
o Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock. If a foreign object should
get into the unit, contact your dealer.
o Do not place anything, not even CDs, CD-Rs, LP records or cassette
tapes, on top of the unit. Doing so could cause damage.
o When removing the power plug from an outlet, always pull
directly on the plug; never yank on the cord itself.
6

Names and functions of parts (display)

a
OCXO A 44.1
A
d
a
Reference clock
This shows the reference clock setting (page 16).
b
Frequency mode
This shows the A and B output frequencies (page 11).
c
10MHz outputs
This shows the connectors that have output set to ON (page
16).
d
Message display area
This shows output settings, setting items, messages and other
information.
b c
B 22.5M 10M 1 34
4 4 . 1 k