Nxdn - Kenwood NEXEDGE NX-240 Manual De Instrucciones

NXDN is a general term for the NXDN wireless communication
protocol which uses 4 Level FSK. Various data communications,
including individual and group voice communications, Status
calls, and GPS data transmission, are possible.
INDIVIDUAL/GROUP CALLS
Each channel is set up with an individual or group ID list number.
To make a call, select the channel with the ID list number you
wish to call, then press the PTT switch to start the call.
• Your dealer may also have set Selcall on PTT for Individual or
Group calls, allowing you to make an Individual or Group call when
pressing the PTT switch.
• To page the target transceiver instead of initiating a voice call,
press the key programmed as [Paging Call].
• If PTT Proceed tone is enabled, the Proceed tone will sound. After
the tone ends, you can being the call.
■ Receiving
When you receive an individual call, a ringing tone will
sound. Respond to the call by pressing the PTT switch.
• If the auto reset timer expires before you respond to the call,
the call will end. Your dealer can set the duration for the auto
reset timer (default is 10 seconds).
When you receive a group call and the received group ID
matches the ID set up on your transceiver, a ringing tone
will sound and you can hear the caller's voice.
STATUS CALL
You can transmit your status (preset by your dealer) to the
target transceiver by pressing the key programmed as [Call 1]
or [Call 2], if they have been set up with an NXDN Status.
• Channels are set up with ID list numbers by your dealer. Select the
desired channel before sending the status call.

NXDN

15