Getting Started - Phonic POWERPOD 415RW Manual Del Usuario

INTRODUCTION
Congratulations on your purchase of the Phonic Powerpod
415RW Powered Mixer. The Powerpod 415RW is built into a rug-
ged wooden cabinet for heavy-duty use. In order to get the best
performance from your Powerpod 415RW, please read all of this
safety and operation manual before operating the mixers and keep
the manual for future reference.
FEATURES
4 mono input channels for a wide range of Microphone and
Line level signals from separate input sockets
Built-in 150 Watt power amplifier
USB recorder and playback device for capturing all perfor-
mances with ease
Bluetooth connectivity for receiving audio from modern
Bluetooth-enabled devices
Class D circuitry on built-in amplifier
Built-in Digital Delay
Super musical 2-band EQ at mono channels
Record out
Tape in with level control

GETTING STARTED

1. Before turning on the power, set the Main output control to
the "0" position.
2. Always turn the power off before connecting or disconnecting
cables.
3. Cleck the AC Voltage before connecting the AC plug.
4. Do not obstruct the back panel at all for proper ventilation.
CHANNEL STRIP DESCRIPTION
1. LOW EQ
The control has shelving response giving 15dB of boost or cut
at 80Hz. Add warmth to vocals or extra punch to guitars, drums
and synths by turning to the right. Turn to the left to reduce stage
rumble, hum or to improve a mushy sound.
2. HIGH EQ
Turn to the right to boost high frequencies, adding crispness to
percussion from drum machines, cymbals and synths. Turn to the
left to cut these frequencies, reducing sibilance or hiss. The control
has a shelving response giving 15dB of boost or cut at 12kHz.
3. LEVEL CONTROL
The Level Control determines the proportion of the channel signal
in the mix, and provides a clear visual indication of channel level.
POWERPOD 415RW
2
1
4
4. MIC & LINE INPUT
The MIC input accepts XLR phone jack while the LINE input
accepts a 1/4" type phone jack. Please use a low impedance
microphone and a properly wired cable for best results. You can
only use one of the two connectors at the same time.
5. EFFECT
This knob decides the signal level which will be sent to the built-in
digital delay effect control.
MASTER SECTION DESCRIPTION
6. DIGITAL DELAY
The signal from the input channels, processed by the built-in digital
delay will feed to the master output. There are three knobs here
to control the effect of digital delay.
TIME - This knob adjusts the internal time of the delays; turn to the
right to increase the interval time between two delays.
REPEAT - To increase the rate of the delays, turn this knob to the
right. You will hear the signal repeat at a faster rate.
LEVEL - The control on the left will adjust the final output level
of the digital delay.
7. POWER INDICATOR
This LED indicator will light up when the Powerpod 415RW is
turned on and active.
6
5
3
4
7
1