Velleman CAMIP21 Manual Del Usuario página 5

Proceed as follows:
1
Take the hole measurements based on the camera stand. Pre-drill a hole with the 5
bit and drill the final hole with the 15 mm bit. Next, place a nylon plug (included)
Also provide a hole for the power cable.
2
Secure the camera stand on the surface using the included screws and a #2 Phillips
screwdriver. Make sure not to overtighten the screws as this may damage the camera stand.
3
Loosen the thumbscrew. Adjust the proper angle and secure with the T-bolt
7. Operation
7.1 Before You Start
•
Before connecting your CAMIP21 camera to the power source, first Before connecting your CAMIP21 camera to the power source, first
connect it to your Wifi router using the included Ethernet cable.
•
After the camera is connected to the router, connect it to the power After the camera is connected to the router, connect it to the power
source and wait until both the red and green LEDs flash. Do not begin
the setup process until both LEDs become steady (roughly 45 seconds).
•
Follow the steps in the following pages to complete the setup.
V. 02 – 01/07/2015
ATTENTION
and wait until both the red and green LEDs flash. Do not begin
CAMIP21
included screws and a #2 Phillips
the screws as this may damage the camera stand.
Ethernet cable.
5
a hole with the 5 mm drill
(included) in each hole.
bolt.
seconds).
©Velleman nv