Safety Instructions; Description Of Function - brennenstuhl AL Serie Manual De Instrucciones

Mobile LED Spotlight AL

SAFETY INSTRUCTIONS

1. The spotlight must be installed and serviced by a qualified technician.
2. Electrical installations may be performed only in compliance with safety regulations (VDE
0100 for Germany).
3. A VDE-certified connection line (at least H05RN-F3G1,0) must be used for the connection.
4. The spotlight must be properly grounded.
5. The spotlight must not be used without all sealing rings properly installed!
6. LED lamps are extremely bright. Please never look into the light.
7. A destroyed protective cover must be replaced with an original Brennenstuhl protective
cover before the spotlight can be used again.
8. If the spotlight's connection to the power network or the connection box is damaged, it must
be replaced by a qualified technician to avoid hazards.
INSTALLATION AND CONNECTION TO POWER SUPPLY
1. Always switch off the power supply before installation (Fig. 1).
2. Installation position: The spotlight should ideally be fastened with the wall bracket.
Remove the retaining bracket from the spotlight (Fig. 2).
3.
4. Mark the position of the drill holes for fastening the retaining bracket (Fig. 3) and drill the
corresponding holes in the wall (Fig. 4). Fasten the bracket to the wall with suitable screws
(Fig. 5).
5. Bring the connection line in through a cable sleeve with a seal (Fig. 6.1).
6. Guide the 3 wires into the screw terminal and screw them all tight (Fig. 6.2).
Pay attention to the markings N = blue wire, earthing symbol = green / yellow wire,
L = brown wire.
Plug the screw terminal into the spotlight's cable entrance (Fig. 6.3).
7.
8. Push the cable sleeve in toward the spotlight and screw it to the spotlight cable entrance
(Fig. 6.4).
9. Fasten the spotlight to the retaining bracket.
10. Adjust the lamp into the desired position and tighten the screws (Fig. 7).
11. Switch the power supply back on (Fig. 8).

DESCRIPTION OF FUNCTION

(only for versions with motion detector) (Fig. 9 + 10)
This lamp is equipped with an infrared sensor. It switches on automatically when the sensor
detects movements in the area. If possible, do not point the motion detector toward swimming
pools, heating air extractors, air conditioners or objects subject to strong temperature variations.
Avoid directing the motion detector at trees or buses or places where pets frequently are.
8