Fisher-Price POWER WHEELS J8760 Manual Del Usuario Con Instrucciones De Montaje página 24

N
IMPORTANT! If you experience a problem with your vehicle, please contact Power Wheels
problèmes
Vehicle does not run
Vehicle was running but
suddenly stopped

e problems and solutIons guIde
cause possIble
Undercharged battery
Charger is not working
Tripped thermal fuse
Loose wire or loose connectors
Dead battery
Electrical switch damage
Motor damage
Loose wire or loose connectors
Tripped thermal fuse
® Consumer Relations.
solutIons
Charge the battery. A new battery should have been
charged for at least 18 hours before using the vehicle for
the first time. After first-time use, recharge the battery for
at least 14 hours after each use. Never charge the battery
longer than 30 hours.
Check all connectors. Make sure the battery connector is
tightly plugged into the charger connector, and that the
charger is plugged into the wall.
Make sure power flow to the wall outlet is "ON".
There is no sure way to tell if your charger is working unless
you have a volt meter. If you suspect there is a problem with
your charger, contact Power Wheels
T he built-in thermal fuse may "trip" and shut down operation
of the vehicle if the vehicle is overloaded or the driving
conditions too severe. Once a fuse has "tripped", release
the button on the handlebar and wait 25 seconds before
operating the vehicle again. To avoid repeated automatic
shutdowns, do not overload the vehicle by exceeding the
18 kg (40 lbs) maximum weight capacity or by towing
anything behind the vehicle. Do not drive up hills or run into
fixed objects, which can cause the wheels to stop spinning
while power is still being supplied to the motors. If a
thermal fuse continually trips, contact Power Wheels
Consumer Relations.
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the motor connector
and that there are no loose wires around the motors.
If your battery is old or if you have not followed Battery
Care instructions, your battery may be dead. If you are
unsure whether or not the battery is dead, contact
Power Wheels Consumer Relations.
®
T he electrical switches can become corroded due to
exposure to water or moisture, or can jam due to loose dirt,
sand or gravel. Contact Power Wheels
Contact Power Wheels Consumer Relations.
®
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the motor connector, and
that there are no loose wires around the motors.
T he built-in thermal fuse may "trip" and shut down operation
of the vehicle if the vehicle is overloaded or the driving
conditions too severe. Once a fuse has "tripped", release
the button on the handlebar and wait 25 seconds before
operating the vehicle again. To avoid repeated automatic
shutdowns, do not overload the vehicle by exceeding the
18 kg (40 lbs) maximum weight capacity or by towing
anything behind the vehicle. Do not drive up hills or run into
fixed objects, which can cause the wheels to stop spinning
while power is still being supplied to the motors. If a
thermal fuse continually trips, contact Power Wheels
Consumer Relations.
Consumer Relations.
®
®
Consumer Relations.
®
®
J8760pr-0721