Power Connection & Charging; Replacing The Fuse - Snooper 6 SERIES Manual Del Usuario

Powering and charging 6 SERIES from the cigarette lighter socket
6 SERIES comes with a power cable designed to plug into your vehicles cigarette lighter socket. The power cable is suitable for both
12v DC and 24v DC vehicles. This lead will power the device but will also charge 6 SERIES's internal battery.
1. Plug the smaller end of the lead into the USB socket on the right hand side of 6 SERIES
2. Plug the other end of the cigarette lighter adaptor into your vehicles cigarette lighter socket.
3. Press and hold the standby power switch on the top left hand side for two seconds to switch the device ON.
Please Note: Do not leave 6 SERIES plugged into the cigarette lighter socket when you start your vehicle. The cigarette lighter
socket is prone to power surges as the vehicle is started and this may cause damage to your unit.
If 6 SERIES does not power up please check that the cigarette lighter socket is clean of any debris, remembering not to insert metal
objects into the socket. Check that the cigarette lighter adaptor is inserted all the way into the socket and check that the fuse in the
cigarette lighter adaptor is operational. If 6 SERIES will still not power up, please check that the cigarette lighter in your vehicle is
functioning correctly.
If 6 SERIES stops operating, the fuse in the cigarette lighter plug may have blown . If it has blown, follow these steps and replace it
with a 3 amp, 5mm x 20mm fast acting fuse.
Caution: Using a fuse that does not meet these ratings or defeating fuse protection can damage your unit, the power
cable, or the vehicles electrical system.
1. Grasp the ring near the tip of the cigarette lighter plug, and then carefully unscrew the ring by turning it counter clockwise.
Caution: If you must use pliers to loosen the ring, be careful not to crush the tip. Never use pliers or other tools to retighten the
ring on the cigarette lighter plug.
2. Pull the ring straight out, then remove the metal tip and old fuse.
3. Check the fuse to see if it has blown. If it has, replace it.
4. Replace the metal tip inside the ring, then place the fuse inside the cigarette lighter plug and screw the ring back onto the plug.
Make sure the metal tip is visible when you reassemble the cigarette lighter plug.
Return to contents
Power Connection & Charging
Replacing the Fuse
12 • EN