Switching On/Off; Settings; Function "Group": Selecting A Frequency From A Group; Function "Freq": Setting The Frequency Directly - Monacor JTS US-36G2/5 Manual De Instrucciones

2) To connect the subsequent unit, e g mixer
or amplifier, two audio outputs are available:
– XLR output (11): balanced output for con-
nection to a microphone input (when the
20 dB level attenuation has been activated,
chapter 6 5) or to a line input
☞
– 6 3 mm jack (10): unbalanced output for
connection to a line input
3) For power supply, connect the power sup-
ply unit provided to the power supply jack
(9) and to a mains socket (230 V~ / 50 Hz)
The receiver is provided with a hook for strain
relief (8): Lead the cable around the hook to
prevent accidental disconnection of the power
supply unit from the receiver
Note: The power supply unit will still consume
power when the receiver has been switched off
Therefore, always disconnect the power supply unit
if the transmission system is not operated for a
longer period of time

5 Switching on/off

To switch on, press the button POWER (7) briefly
To switch off, keep the button POWER pressed
until the display indicates

6 Settings

Use the buttons SET
tings for the receiver:
1) To call up the setting mode, keep the but-
ton SET pressed for 3 seconds: The display
indicates and the first function is se-
lected ("GROUP" or "FREQ", whichever func-
tion was used to set the current transmission
frequency)
2) To select a function, use the button SET:
Press the button repeatedly until the desired
function is reached
3) To change the setting, use the button
or When a function offers two setting op-

tions (e g group number and channel num-
ber), use the button SET to go from the first
option to the second option
4) To save the setting, press the button SET
The display indicates
mode is exited
If no setting has been changed when the last
function is reached, the setting mode will be
and (6) to make set-
 
and the setting
exited when the button SET is pressed (indication
)
For detailed information on the functions refer to
the following chapters
6.1 Function "GROUP":
Selecting a frequency from a group
When this function is selected,
ing on the display
The function „GROUP" can be used to select the
transmission frequency from a group of preset
frequencies (channels) Six groups are available;
the number of channels in each group varies:
refer to the table on page 3
This function is suggested when multiple
audio transmission systems are operated at the
same time: For each system, a different channel
can be selected from the same group In ideal
conditions, all channels from a group can be used
at the same time without mutual interference
1) The letter "G" starts flashing on the display:
Use the button
2) Press the button SET
3) The letters "CH" start flashing on the display:
Use the button
4) To save the setting, press the button SET
6.2 Function "FREQ":
Setting the frequency directly
When this function is selected,
ing on the display
The function "FREQ" can be used to select the de-
sired frequency from 1441 available frequencies
1) The first three digits of the transmission fre-
quency start flashing on the display: Use the
button or

of 1 MHz

2) Press the button SET
3) The last three digits of the transmission fre-
quency start flashing: Use the button
to set the frequency in steps of 0 025 MHz
If the frequency is identical to the fre-
quency of a channel in a group, the group
number and the channel number will appear
on the display
Note: When the frequency has been set and the
setting mode is called up again to select another
or to select the group
 
or to select the channel
 
to set the frequency in steps

starts flash-
starts flash-
or
 
11