Reinstall Grease Filter(S) - Broan Elite EW43 Serie Manual De Instalación,Utilización Y Cuidado

Ocultar thumbs Ver también para EW43 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

12. INSTALL THE DECORATIVE FLUE (
N
-
:
ON
DUCTED INSTALLATION
Slide up the upper flue until it is aligned with the plenum. Secure the upper flue to the
plenum using 2 M4 x 12 Phillips round head screws.
Remove protective plastic film covering the upper flue and the hood.
D
:
UCTED INSTALLATION
Slide up the upper flue until it is aligned with its mounting bracket. The bracket must be inside
the flue. Secure the upper flue to its bracket using 2 M4 x 12 Phillips round head screws.
NOTE: Duct not shown in illustration to ease understanding.
Remove protective plastic film covering the upper flue and the hood.

13. REINSTALL GREASE FILTER(S)

N
-
:
ON
DUCTED INSTALLATION
Install a charcoal filter (included in the non-duct kit) on each aluminum grease
filter back (A). Hold the charcoal filter in place by inserting both ends of
3 metal strips (included in the non-duct kit) in each aluminum grease filter
frame (B).
A
:
LL INSTALLATIONS
To reinstall the grease filters, align rear filter tabs with slots in the hood. Pull
down the metal latch tab, push each filter into position and release. Make
sure filters are securely engaged after installation.
)
CONTINUED
A
HA0145
HD1161
9
HO0293
U
PPER FLUE MOUNTING BRACKET
F
RONT VIEW
U
PPER
FLUE
HO0295
B

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido