SEVERIN CS 7976 Instrucciones De Uso página 8

head will cause the appliance to switch off
automatically in order to prevent personal
injury or damage to the appliance.
Batteries
Th is appliance requires two batteries of
type LR14 / 1.5 V (size C);
alkaline batteries is preferable, as they are
longer-lasting than the standard carbon-
zinc batteries. Th e batteries are inserted as
follows:
– Slide the battery compartment cover in
the direction indicated by the arrow and
take it off .
– Insert the batteries
the schematic
compartment, ensuring correct polarity
(+/-).
– Replace the compartment cover and slide
it back until it is heard locking into place.
When the lint chamber is empty, a
signifi cant decrease in operating speed
is a clear indication that the batteries
are exhausted, and that they should be
replaced.
Never dispose of old batteries in your
domestic garbage. Old batteries must be
disposed of through local 'special garbage
collection points' .
Operation
– Place the item to be treated on a level
surface.
– Remove the protective cover from the
head. For coarser wool surfaces, the use of
the spacer ring is recommended.
– Use the On-/Off switch to turn the
appliance on. Th e shaving blades inside
the shaving head start rotating. When
they come into contact with the surface of
the area to be treated, a distinct noise can
be heard. Th is is normal.
the use of
according
diagram inside
– Guide the shaving head gently and without
exerting any pressure over the fabric to be
treated. Lint and fuzz balls are removed
and collected in the lint chamber.
Th e chamber should always be emptied
in good time. If the motor seems to lose
power, or if it stops working completely,
the lint chamber may be over-full.
– Turn the appliance off aft er use.
General care and cleaning
Before cleaning the appliance, turn the
motor off and remove the batteries from
the battery compartment.
to To avoid the risk of electric shock, do not
the clean the appliance with water and do not
immerse it in water.
Do not use abrasives or harsh cleaning
solutions.
– To empty the lint chamber, slide it out of
the appliance in the direction indicated
by the arrow. Once emptied, slide the
chamber back into the appliance until it is
heard locking into place.
– Th e exterior housing may be wiped with a
slightly damp soft cloth.
– Th e shaving head can be cleaned as
follows:
– Remove the spacer ring and the protective
cover from the appliance.
– Take off the shaving head by unscrewing it
in an anti-clockwise direction.
– Caution
removing the lint residues. Th e blades are
very sharp, and there is a risk of injury.
– Replace the head back on the appliance
and turn it clockwise to secure. Replace
the protective cover and – if applicable –
the spacer ring.
Disposal
Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.
Guarantee
Th is product is guaranteed against defects
8
: Exercise extreme caution when